User manual TOSHIBA VTW2185

[. . . ] MODEL VTW2185 USER GUIDE DIGITAL VIDEO Region discs only Combination 21" Flat TV and Video Recorder/DVD Video Player FASTEXT IMPORTANT Unauthorized recording of copyright television programmes, films, video tapes and other materials may infringe on the rights of copyright owners and be contrary to copyright laws. WARNING To prevent fire or shock hazard, do not expose this equipment to rain or moisture. MAINS SUPPLY This unit is designed to operate from AC 230 ~ 240V 50Hz household mains supply. This unit is supplied with an approved 13 amp (BS 1363) fused mains plug. When replacing the fuse always use a 5 amp (BS 1362) approved type. Never use this plug if the fuse cover is missing. [. . . ] The user must remember to turn off the unit using the ON/STANDBY button in order to reset the timer. 2 If the timer has not been set, the VIDEO Plus+/PROG. button has to be pressed twice to show the timer program list, the next press shows the ON/OFF TIMER setting screen and the fourth presses returns to normal picture. 23 SAT 13 : 00 14 : 30 3 LP : : : : : : : : : : : : : : SELECT : / ENTER CLEAR :CANCEL EXIT : MENU ON/OFF TIMER SET ON TIMER 7 : 45 CH 3 MON-FRI OFF TIMER 8 : 30 SELECT : ENTER : ENTER : MENU EXIT SET SET TO CANCEL A PROGRAM Press the or button to select the TIMER REC SET option in the MENU, then press the ENTER button. Press the or button to select the unnecessary program, and press the CANCEL button to cancel the program. IF THE PROGRAM OVERLAPS ANOTHER NOTE: Do not overlap programs as portions of the conflicting programs will be lost. The first recording time has priority over the next recording time as shown in the diagram. 8 : 00 9 : 00 10 : 00 11 : 00 SELECT : / ENTER EXIT : MENU NOTE: The everyday/every week recording can be made continuously until the recording is canceled or the tape reaches the end. During timer recording, the automatic rewinding mechanism does not function. You can correct or cancel the programmed setting in program confirm mode. If you press an invalid button during timer recording (such as PLAY, STOP, REC etc), "RECORDING IN PROGRESS" will appear on the TV screen for approx. 4 seconds. 32 ONE-TOUCH TIMER RECORDING (OTR) The one-touch timer recording feature provides a simple and convenient way to make a timed recording. EXAMPLE: One-touch Timer Recording for 30 minutes. Press the ON button to turn on the unit. Then press the TV/VCR button to select TV/VCR mode. Load a video cassette with the erase prevention tab intact. Press the SP/LP button to select the desired tape speed (SP or LP). SP or LP will appear on the screen. 1 5 3 4 Press the Direct Channel Selection buttons or or button to select the channel CH/PAGE to be recorded (Example: Channel 2). Press the REC buttons to begin recording. Press the buttons again to stop recording after 30 minutes. Each additional press of the REC buttons will increase recording time as shown below, up to a maximum of 5 hours. "OTR" will appear on the screen. OR CH 2 OTR 0 : 30 CH 2 CH 2 INDEX NOTE: Press the REC buttons to increase the time needed for recording (See the chart below). Press once twice 0:30 3 times 4 times 5 times 6 times 1:00 1:30 2:00 3:00 7 times 4:00 8 times 5:00 9 times NORMAL REC Recording time NORMAL REC To cancel OTR, press the STOP button. When the tape speed LP is selected, the recording time can be set up to 10 hours. 33 NICAM STEREO RECORDING AND PLAYBACK RECORDING This unit is capable of recording sound in Hi-Fi system. NICAM STEREO broadcasts are recorded in its original sound system regardless of the setting. If you wish to record NICAM programmes, select NICAM "AUTO" as follows. If the NICAM sound has noise, select the TV station which has noisy NICAM sound, then set NICAM to OFF. Press the TV/VCR button to select TV/VCR mode. [. . . ] 46 43 46 46 43 55, 56 REMOTE CONTROL Aim it at the remote control sensor. Operate within 5 metres and reduce the light of the room. 6 6 6 6 6 NOTE: In the case that the scart input of the unit is connected to AV1 scart of a recordable equipment such as a VTR, DVD+VTR, DVD-R etc and when the input of the recordable equipment is also selected to AV1, there maybe some white flashing lines on the screen and a high pitch sound may also be heard. This is due to the feedback loop of the connections to the unit and it is not a defect of the unit. * This product incorporates copyright protection technology that is protected by method claims of certain U. S. [. . . ]