User manual TP-LINK SAFESTREAM TL-ER604W

[. . . ] http://www. tp-link. com is a registered trademark of TP-LINK TECHNOLOGIES CO. , LTD. Other brands and product names are trademarks or FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Service Port - The numbers of External Service Ports. Internet address - Displays the WAN IP address of this router, so that others can access FTP through this address. If WAN type is PPPOE/PPTP/L2TP, there would be two connections. Therefore, users can access FTP Server via two connections. Users in a -49- SAFESTREAM TL-ER604W 300Mbps Wireless N Gigabit Router private LAN can access FTP Server via Public Address while internet users can access FTP Server via Internet Address. To set up your FTP Server, please follow the instructions below: 1. Plug an external USB hard disk drive or USB flash drive into this router, and then the screen will appear as shown in Figure 4-36. Figure 4-36 FTP Server Configuration 2. 4. Click the Enable/Disable box to enable/disable internet access to FTP from Internet port. Change the Service Port to specify a port for FTP Server to use. (The default is 21, do not change unless necessary. ) Click Add New Folder to add new folders for the FTP Server. The screen will show as Figure 4-37. Figure 4-37 Add or Modify Share Folder -50- SAFESTREAM TL-ER604W 300Mbps Wireless N Gigabit Router Display Name - You can enter a display name for the share folder. Share entire partition - You can select this option and then the folders contained in this partition will all be shared. Folder Location- Displays the location of this folder. Select - You can select this option to share the specified folder. Folder - Name of folders that is in current path. upper - You can click the upper button to get into the upper folder. -53- SAFESTREAM TL-ER604W 300Mbps Wireless N Gigabit Router Save - You can click the Save button to save your settings and the page will be redirected to the media server configuration page. Back - You can click the Back button to discard the settings and just go to the media server configuration page. To add a new share folder for your media server, please follow the instructions below: 1) 2) 3) Select the Share entire partition or a specified folder option. Enter the display name of the share folder in Display Name edit box. Click the Save button to save the configuration and the page will be redirected to the media server configuration page as shown in Figure 4-43. Figure 4-43 Media Server Setting 4. Click the Scan All button to scan all the share folders immediately. You can also select the Auto-scan, at same time, select an auto scan interval time by drop-down list. In this case, the media server will auto scan the share folders. [. . . ] If the wireless connection is ready, but you can’t access the router, check the IP Address of your wireless stations. -108- SAFESTREAM TL-ER604W 300Mbps Wireless N Gigabit Router Appendix B: Configuring the PCs In this section, we’ll introduce how to install and configure the TCP/IP correctly in Windows XP. First make sure your Ethernet Adapter is working, refer to the adapter’s manual if needed. Install TCP/IP component 1) On the Windows taskbar, click the Start button, point to Settings, and then click Control Panel. 2) Click the Network and Internet Connections icon, and then click on the Network Connections tab in the appearing window. [. . . ]