User manual TP-LINK TL-PA2015PKIT

[. . . ] No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. , LTD. Copyright © 2008 TP-LINK TECHNOLOGIES CO. , LTD. All rights reserved. http://www. tp-link. com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. Identifying External Components POWER+DATA IN: Connect to the PSE or PoE Supplier Adapter with a CAT5 UTP cable. 2 LAN OUT: Connect to the Ethernet device with CAT5 UTP cable to transmit data. DC OUT: Connect to the power port of the Ethernet device with the provided power cable to supply the power of 5V or 12V DC. PWR: Power LED, a steady green light indicates that the connected PSE or PoE Supplier Adapter can supply power. Power-mode switch: You can choose the DC output as 12V or 5V by turning the switch left or right. Chapter 3. Connecting the PoE Receiver Adapter You can use TL-PA2015PKIT PoE Receiver Adapter with PSE or PoE Supplier Adapter to expand your network to where there are no power lines or outlets, where you wish to fix devices such as APs, IP Cameras or IP Phones, etc. The following steps will tell you how to connect the PoE Receiver Adapter correctly. 3 1. 2. Use a CAT5 UTP cable to connect a PoE port of the PSE( ex. Choose the appropriate DC output by the Power-mode Switch, default output is 12V. Note: Please make sure that the output is correct, different voltage may destroy the device. Connect the LAN OUT port to the Ethernet device with CAT5 UTP cable for data transmitting. [. . . ] Connect the LAN OUT port to the Ethernet device with CAT5 UTP cable for data transmitting. Connect the DC OUT port to the power port of the same Ethernet device with the provided power cable. Note: The power of Ethernet device is suggested to be under 10W. [. . . ]