User manual TP-LINK TL-SG3109 EMBEDDED WEB SYSTEM USER GUIDE

[. . . ] Embedded Web System User Guide TL-SG3109 9-port Gigabit Managed Switch TL-SL3428 24+4G Gigabit Managed Switch TL-SL3452 48+4G Gigabit Managed Switch Rev: 1. 0 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK Technologies Co. , Ltd. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK Technologies Co. , Ltd. [. . . ] VLAN 4095 is defined as per standard and industry practice as the Discard VLAN. Packets classified to the Discard VLAN are dropped. Frame Type -- Specifies the packet type accepted on the port. The possible field values are: ­ Admit Tag Only -- Only tagged packets are accepted on the port. ­ Admit All -- Both tagged and untagged packets are accepted on the port. Ingress Filtering -- Indicates whether ingress filtering is enabled on the port. The possible field values are: ­ Enable -- Enables ingress filtering on the device. Ingress filtering discards packets that are defined to VLANs of which the specific port is not a member. ­ Disable -- Disables ingress filtering on the device. Reserve VLAN -- Indicates that the VLAN selected by the user is reserved, if not in use by the system. To modify VLAN interface or LAG settings: 1. The VLAN / LAG Interface Settings Page opens. Figure 76: VLAN / LAG Interface Settings Page 2. Modify the Port VLAN Mode, Dynamic, Frame Type, Ingress FIltering, and Reserve VLAN fields. The VLAN or LAG interface is configured and device information is updated. 7. 3. 4 Configuring GARP This section contains information for configuring Generic Attribute Registration Protocol (GARP). This section includes the following topics: Defining GARP Defining GVRP 7. 3. 4. 1 Defining GARP Generic Attribute Registration Protocol (GARP) protocol is a general-purpose protocol that registers any network connectivity or membership-style information. GARP defines a set of devices interested in a given network attribute, such as VLAN or multicast address. When configuring GARP, ensure the following: The leave time must be greater than or equal to three times the join time. The leave-all time must be greater than the leave time. Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set differently on the Layer 2-connected devices, the GARP application does not operate successfully. Click System > Bridging Config > VLAN > GARP. The GARP Parameters Page opens: Figure 77: GARP Parameters Page The GARP Parameters Page contains the following fields: Copy from Entry Number -- Indicates the row number from which GARP parameters are copied. [. . . ] Logs into a remote computer via a network, executes commands, and transfers files from one computer to another. Permits a device to operate independently from other devices. Retains the exact device configuration when the device is powered down or rebooted. Subnets are portions of a network that share a common address component. [. . . ]