User manual TP-LINK TL-WA5210G

[. . . ] Adjust the direction of your CPE for the best signal. Place the straps through the slots on the back of the CPE and then around the pole. English Connect one end of an Ethernet cable to the POE port of the provided Power Injector and the other end of the Ethernet cable to the LAN port of the CPE. Then, connect the LAN port of the Power Injector to a PC using another Ethernet cable. [. . . ] click Wireless Click Antenna Alignment 17 Appendix 1: External Antenna Installation 1 External Antenna Connection 1. If you have an external antenna with the RP-SMA port, you could connect it to the RP-SMA port of your CPE directly. If you have an external antenna with N type port, you could connect it to the TL-WA5210G with a pigtail cable. To protect your product, you could also add a surge protector. The complete connection would be simply illustrated as below. English Note The pigtail cable is used to change the N type port to RP-SMA type port. 2 Note Configure the External Antenna You will need to assign your computer a Static IP address within the same range as the AP’s IP address. See the Appendix 2: Troubleshooting - T3 if you need assistance. 18 Login Open your web browser, type http://192. 254 in the address field and press Enter A dialog box will prompt you for the User name and Password. How do I restore my AP’s configuration to its factory default settings?With the AP powered on, press and hold the RESET button for about 8 seconds before releasing it. Hold it in for about 8 seconds You will need to assign your computer a Static IP address within the same range as the AP’s IP address. See the Appendix 2: Troubleshooting - T3 if you need assistance. 1) Restore the AP’s configuration to its factory default settings. If you don’t know how to do that, please refer to previous section T1; 2) Use the default user name and password: admin, admin; 3) Try to reconfigure your AP by following the instructions of this QIG. What can I do if I cannot access the web-based configuration page?You should first configure your computer’s IP Address. Please follow the steps below to finish your PC configuration. ¾ For Windows 7 OS Go to Start > Settings > Control Panel, and then you will see the following page. Click View network status and tasks 20 Click Change adapter settings English Right-click Local Area Connection Click Properties Double-click Internet Protocol Version 4 (TCP/IPv4) 21 Select Use the following IP address Enter 192. 0 into the Subnet mask field Select Use the following DNS server addresses Enter the DNS server address provided by your ISP or network administrator Click OK English ¾ For Windows XP OS Go to Start > Control Panel, you will then see the following page. [. . . ] For at gøre dette, bedes du klikke på I agree to these terms of use Klik på Login 136 Bem Når du først har valgt regionen kan den ikke ændres med mindre du nulstiller enheden til fabriksindstillinger og omkonfigurerer den igen. English Safety Information z When a product has a power on/off button, the power on/off button is one way to turn-off the product. For products without the on/off button, the only way to completely turn-off the product is to disconnect the product or the power adapter from the power source. The disconnected device shall remain readily operable. [. . . ]