User manual TP-LINK TL-WR842ND

[. . . ] 0 1910010635 COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO. Com FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] Click the Add New… button, the next screen will pop-up as shown in Figure 4-35. Select a common application from the Common Applications drop-down list, then the Trigger Port field and the Incoming Ports field will be automatically filled. If the Common Applications do not have the application you need, enter the Trigger Port and the Incoming Ports manually. Select the protocol used for Trigger Port from the Trigger Protocol drop-down list, either TCP, UDP, or All. Select the protocol used for Incoming Ports from the Incoming Protocol drop-down list, either TCP or UDP, or All. Click the Save button to save the new rule. Click the Modify in the entry you want to modify. If you want to delete the entry, click the Delete. Click the Enable All button to make all entries enabled Click the Disable All button to make all entries disabled. When the trigger connection is released, the corresponding opening ports will be closed. Each rule is allowed to be used only by one host on LAN synchronously. The trigger connection of other hosts on LAN will be refused. Incoming Ports cannot overlap each other. 3 DMZ Choose menu “Forwarding → DMZ”, you can view and configure DMZ host in the screen as shown in Figure 4-36. The DMZ host feature allows one local host to be exposed to the Internet for a special-purpose service such as Internet gaming or videoconferencing. DMZ host forwards all the ports at the same time. Any PC whose port is being forwarded must have its DHCP client function disabled and should have a new static IP Address assigned to it because its IP Address may be changed when using the DHCP function. Enter the IP Address of a local host in the DMZ Host IP Address field. Note: After you set the DMZ host, the firewall related to the host will not work. 4 UPnP Choose menu “Forwarding → UPnP”, you can view the information about UPnP (Universal Plug and Play) in the screen as shown in Figure 4-37. The UPnP feature allows the devices, such as Internet computers, to access the local host resources or devices as needed. UPnP devices can be automatically discovered by the UPnP service application on the LAN. [. . . ] 3 Type the Router’s LAN IP address (the default IP is 192. In the Preferred DNS Server field you can enter the same value as the Default gateway or type the local DNS server IP address. MIMO uses multiple transmitter and receiver antennas to allow for increased data throughput via spatial multiplexing and increased range by exploiting the spatial diversity, perhaps through coding schemes like Alamouti coding. The Enhanced Wireless Consortium (EWC) [3] was formed to help accelerate the IEEE 802. [. . . ]