User manual TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE. We hope that this TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE user guide will be useful to you.
Lastmanuals help download the user guide TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE.
Manual abstract: user guide TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE
Detailed instructions for use are in the User's Guide.
[. . . ] Installation and Operation of the TransTel Battery Module for the CPE ONE
Introduction The Battery Module (CPE-BM) houses two 2. 0 Ahr batteries and circuitry for charging the batteries. The CPE-BM is designed to provide uninterrupted service for the CPE in case of temporary power outages. [. . . ] 5555 Oakbrook Parkway Norcross, GA 30093 Tel. 770 368-8343 Fax 770 368-8382
10/96
and pull it out to a length of two to three inches. Orient the bottom of the CPE above the battery module as indicated in Figure 1.
Hold the CPE ONE and the battery module tightly together and locate the four captive screws in the corners of the bottom side of the battery module. Using a blade screw driver, tighten by turning the captive screws clockwise. If desired, the wall mounting brackets can now be attached to the bottom plate of the battery module. To do this, one of the brackets must be mounted parallel to the above narrow face of the battery module shown in Figure 1. The other bracket must be mounted at the opposite bottom section.
Figure 1. CPE ONE (top) in correct orientation above Battery Module for joining the two units. Note that the three flat-head screws of the CPE ONE (top part of drawing) and the three screws of the Battery Module (bottom part of drawing) line up on the same side.
Operation of the CPE-BM Move the slide switch of the CPE ONE to ENABLE. Plug the power cord into the receptacle of the CPE ONE. After a delay of five seconds the yellow diode of the CPE ONE will light up and the unit will turn on. To check correct operation unplug the power cord. [. . . ] If the above alignment was correctly carried out, the two units will fit perfectly. If the two units do not fit together, repeat the above orientation procedure.
Page 2
Page 3 [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual TRANSTEL GROUP CPE-BM BATTERY MODULE FOR CPE ONE will begin.
