User manual TRAYNOR TVM10

[. . . ] When using electric products, basic precautions should always be followed, including the following: Your unit should be connected to a power source only of the voltage specified in the owners manual or as marked on the unit. Do not use with an extension cord or receptacle unless the plug can be fully inserted. Precautions should be taken so that the grounding scheme on the unit is not defeated. Do not place this product on an unstable cart, stand, tripod, bracket or table. [. . . ] When the charger is plugged in and the Power LED fails to illuminate, the unit must be recharged for 24-hours. If the Power LED fails to illuminate Yellow after charging, the internal battery may be deemed dead. Refer to Owner's Manual for more detailed instructions about replacing the internal battery. General The Traynor TVM10 is a 10-Watt battery powered combo-amplifier that answers the need for a portable, all-purpose sound system. The TVM10 can be used practically anywhere. The amp features RCA auxiliary input jacks, which may be used to connect sound sources such as CD players, tape decks, MP3 players or even laptops (using the appropriate audio adapters). Input 1 This versatile input has been optimized to accept either low or high-impedance microphones, although any line level signal may also be used. The combiconnector accepts cables with either an XLR or ¼inch TRS phone plugs. volume 1 The Channel 1 volume control adjusts the level of the audio signal connected to the Input 1 jack. Input 2 An instrument (guitar, bass or keyboard) or a high impedance microphone may be connected to the TVM10 using this ¼-inch phone jack using a standard ¼-inch shielded cable. It is suggested that all four controls be set to the center, or 0, position (nominal) prior to operation, adjustments may be made to achieve the desired tone. If feedback occurs while you are using a microphone, turn down the Treble and/or High Mid until it stops. Input (Media) RCA jacks can be used to connect a tape deck, CD player, MP3 player, drum machine, computer or any line-level audio source. Since the TVM10 is a mono amplifier, these jacks sum the signals internally (mixing the incoming L and R stereo signals into a mono signal). Connect to both RCA jacks as usual, so that both channels (L and R) are amplified. Output from a mixer), connect to either the L or R jack. Phones Jack Connect standard stereo headphones to this jack using a ¼-inch stereo plug. When fully charged, the battery should provide approx. The TVM10's battery charging system is not designed as an AC power source. Charger LED This LED illuminates when the amp is being charged. [. . . ] Unlimited Warranty Yorkville's two and ten-year unlimited warranty on this product is transferable and does not require registration with Yorkville Sound or your dealer. If this product should fail for any reason within two years of the original purchase date (ten years for the wooden enclosure), simply return it to your Yorkville dealer with original proof of purchase and it will be repaired free of charge. This includes all Yorkville products, except for the YSM Series studio monitors, Coliseum Mini Series and TX Series Loudspeakers. Freight charges, consequential damages, weather damage, damage as a result of improper installation, damages due to exposure to extreme humidity, accident or natural disaster are excluded under the terms of this warranty. [. . . ]