User manual TRAYNOR YS1027

[. . . ] Use only with cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the manufacturer. The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. [. . . ] User Tip: Don't use both inputs at the same time as they're not intended for connecting more than one instrument at a time. Compressor To increase the consistency of your tone and further the performance of the power amplifier, we have provided an adjustable compressor. This compressor is simple to use, with only a simplethresholdcontroltomakeadjustments. thecompressionratiois2:1andtheattack/ release-timeispresetoptimally. Note: To use the Compressor, rotate the control clockwise until the desired threshold is reached. It will be apparent to you audibly as well as visually; a red LED (located to the right of the control) will illuminate as the compressor limits the signal. The LED will also indicate how much compression is being applied by its intensity and duration. Thisisanormal compromise when achieving so much overdrive. User Tip: Many unique sounds can be obtained by changing some controls in conjunction with the Distortion control. Some bassists prefer minimal distortion with a lot of Scoop, some may prefer massive overdrive (and lots of midrange growl) and others may go for deep dry bass. These sounds can be achieved easily by adjusting the Scoop, the Distortion and the Distortion's Mix controls in conjunction with each other. Some players find this useful as a boost for loud passages or soloing. Note, when using the footswitch the front panel Distortion selection switch is deactivated. Whenrotated clockwise, into the Wet region, the overdriven sound becomes more apparent. This is a handy feature that puts you in control of your overdrive tone. User Tip: It's a good idea, when starting out, to center all tone controls. While playing, adjust them until you achieve the desired sound. User Tip: To use this control, set the position of the Parametric Mid level control to cut or boost. rotate the Frequency control until the desired frequency range is found. Once the frequency range is chosen, adjust the Parametric Mid level until the desired cut or boost level is achieved. [. . . ] Note: When the Mute switch is engaged, a signal will not be sent to the mixing console through the XLR output. User Note: The Effects Send jack can also be used as an additional line out for sending signals to another power amplifier. The output of this jack is not muted when the Mute switch is enabled. Preamp Tube Replacement UseonlyYorkvilleSoundpartnumber"12AX7SORTED"whenreplacingpreamplifiertubes as they have been specifically selected for this product. [. . . ]