User manual TRAYNOR YS1035

[. . . ] Use only with cart, stand, tripod, bracket, or table recommended by the manufacturer or sold with the product. Follow the manufacturer's instructions when installing the product and use mounting accessories recommended by the manufacturer. The apparatus should not be exposed to dripping or splashing water; no objects filled with liquids should be placed on the apparatus. Terminals marked with the "lightning bolt" are hazardous live; the external wiring connected to these terminals require installation by an instructed person or the use of ready made leads or cords. [. . . ] Some bassists prefer minimal distortion with a lot of Scoop, some may prefer massive overdrive (and lots of midrange growl) and others may go for that deep dry bass. These sounds can be achieved easily by adjusting the Scoop, the Distortion and the Distortion's Mix controls in conjunction with each other. Some players find this useful as a boost for loud passages or soloing. Note, when using the footswitch the front panel Distortion selection switch is deactivated. This control blends an underlying clean tone below the distorted tone. In the Dry counter-clockwise setting, clean signal is allowed to dominate the mix with no distortion. When rotated clockwise, into the Wet region, the distortion sound becomes more apparent. The Distortion overdrive will continue to increase until it is the dominant sound in the mix (fully Wet position). This helps you achieve a perfect Wet/Dry blend between a completely clean and completely saturated distortion tone. This is a handy feature that puts you in control of your distorted tone. Compressor To increase the consistency of your tone and further the performance of the power amplifier, we have provided an adjustable compressor. This compressor is fairly simple to use, with only a simple threshold control to make adjustments. the compression ratio is 2:1 and the attack/release-time is preset optimally. Note: To use the Compressor, rotate the control clockwise until the desired threshold is reached. It will be apparent to you audibly as well as visually; a red LED (located to the right of the control) will illuminate as the compressor limits the signal. The LED will also indicate how much compression is being applied by its intensity and duration. The five overlapping controls cover the entire audio spectrum. The Bass adjusts the level of the low frequency range, Low Mid the next range up, Hi Mid covers higher notes and middle harmonics and the Treble control regulates the upper harmonic range. Each tone control has a variable boost and/or cut of 15 db. User Tip: It's a good idea, when starting out, to center all tone controls. While playing, adjust them until you achieve the desired sound. User Tip: To use this control, set the position of the Parametric Mid level control to cut or boost. [. . . ] Allow at least an inch clearance for each side. Always keep the rear of the unit unobstructed. Rack-mounting the DynaBass 800H chassis will not affect intake/exhaust airflow as long as the rear of the rack casing is open during operation and 1 inch of clearance along the sides is unobstructed. Preamp Tube Replacement Use only Yorkville Sound part number "12AX7SORTED" when replacing preamplifier tubes as they have been specifically selected for this product. [. . . ]