User manual TREK BIKES INCITE 11I QUICK START GUIDE

[. . . ] trekbikes. com (920) 478-4670 CONTENTS Safety and general guidelines. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Functions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 Setting the computer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Wrap the wire around the front brake cable, diverting the determined amount. Continue routing the wire, either by wrapping around the fork or frame tube, or attach the wire to the fork or frame tube with electrical tape. As needed, solidify the wire attachment with either nylon ties or electrical tape. Figure 8- Magnet placed on crankarm, aligned with sensor on chainstay To install the sensor These instructions are written for the front wheel, but apply equally to installing the magnet and cadence sensor which go on the left crank and the frame's chainstay. The magnet must pass across the line on the sensor (Figure 10). Orient the sensor so that the clearance between the sensor and the magnet is between 1 to 3mm. The sensor can be rotated around the fork blade or crank about 45 degrees. If needed, the sensor and magnet can be moved up or down the fork and wheel to change the clearance. For the wireless sensor, install the rubber "foot" in the sensor (Figure 11). Attach the sensor with nylon ties, but do not fully tighten. With the computer in the computer base, check the alignment of the sensor and magnet by spinning the wheel and noting if the computer is displaying speed. If the computer shows current speed, the sensor is reading the magnet. The Max setting restarts at 0. Second wheel size (Wheel 2) The following features are only on the Incite 8i. The second wheel size allows the computer to calculate using the wheel size of a second bike. For example, you can use the computer on your road bike with 700c racing wheels, then move it to your mountain bike with 26" wheels. In both cases, the trip distance and speed will be accurate. The computer adds the data for the two wheel sizes resulting in the total distance (ODO). Step 8 in these instructions assumes you want to leave the odometer at its existing setting. If you want to change the odometer, refer to the steps in To set the odometer and wheel size. To set second wheel size 1. The mileage conversion (MH or KMH) will flash. Hold both Mode and Set at the same time. The wheel select icon appears in the upper left corner. Push Mode to select each digit of the odometer. [. . . ] If the electrical contacts between the computer and its base become saturated, the electrical signals may become irregular or interrupted entirely. If the computer is to be used in heavy rain, etc. , we recommend that a plastic bag be put over the computer and its base. The other parts of the computer system are waterproof. REPLACING THE BATTERY If the computer is giving erratic information, the battery may be running low on power. Replace the battery whenever the computer malfunctions, or every 6 months. [. . . ]