User manual TREK BIKES SENSOR 1998

[. . . ] Precautions Remember to watch the road or trail while riding. Watching your bicycle computer makes it difficult to see upcoming obstacles. Awareness of potential road, trail or traffic problems should be your main concern. Main Unit/Accessories 2 3 7 6 4 1 Contents: 1. Bracket Rubber Pad Second Point First Point Measure the distance which is your circumference Table 1. [. . . ] Installing/Replacing the battery. Remove the battery cover by using a narrow flat blade or similar opener as illustrated in fig. Insert a new battery (3v) CR2032, position the (+) pole upward as illustrated. Place the battery properly into the case and close the cover securely. After the battery is installed speed scale and wheel size can be set. 3. Setting Speed Scale Choose KM for Kilometers or Miles. After the battery is installed all displays will be illuminated, then "KM" Page 2 Page 3 fig 5 fig 4 alone will remain flashing on the screen as in fig. To make choice please insert computer head into main bracket. Bring Magnet in contact with tip of wheel sensor. When desired choice is on screen pull magnet away from wheel sensor to lock choice and move on to next step. Loosen the spoke screw and place spoke in spoke channel. Tighten spoke screw so that it cinches the magnet securely to the spoke. Place the wheel sensor on the appropriate fork leg. Install the zip tie through wheel sensor and pull tight. Adjust the wheel sensor until it is 3-5mm from the wheel magnet. The magnet should line up with indent on wheel sensor. Spoke Channel Spoke Screw Odometer (total distance) (0. 0-9999 kms or 6213 miles)-ODO The total distance is continuously measured, accumulated and displayed until next reset or the battery is changed. When 9999 kms or 6213 miles is reached the odometer returns to zero and counting begins anew. Trip Distance (0. 0-999. 9 kms)-DIS The trip distance from start to current point is displayed. Trip distance will start calculating if signal is received, and stop calculating when signal stops. Auto Start/Stop Test Mount the computer in the bracket. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. If not, adjust wheel magnet and wheel sensor as described in installation steps 9. Refer to the following steps for the operation of your Sensor computer. All functions - Current Speed(S), Odometer(ODO) and Trip Distance(DIS) will automatically start and stop when signal is received or stopped. Auto Scan All the functions (ODO, DIS) will automatically scan and each display mode will last 3 seconds. [. . . ] (3V/DC) Is there anything on the Wipe the contact clean contact of the main unit or on the bracket?Are the wheel sensor and magnet too far apart?8" and re-adjust correctly. -20. 0 C to 50. 0 C (-40 F to 122. 0 F) 100mm-2999mm Approx. 1 year Are the marking lines of the Refer to "installation fig. [. . . ]