User manual TREK BIKES SENSOR 2.0

[. . . ] Setting the wheel circumference (100mm-2999mm) Sensor 2. 0 has 2 wheel circumference settings. The display shows 1/2155 and the last two digits "55" will flash. Advance them rapidly by holding down the R button, or one at a time by pressing the R button ( or go backward by holding the L button). When desired number (confirmed and marked from fig. [. . . ] Remove the screw from the magnet and install it on one of the feasible spokes opposite the wheel sensor. Mount the wheel sensor on the fork blade opposite the magnet using the zip tie provided. Adjust the sensor until it is 3-5mm from the magnet, then tighten it. Cut the excess zip tie off. Spoke Channel Spoke Screw a. 12/24 hours alternative. When clock is displayed, press both L & R buttons at the same time. Clock will blink then press L or R button to switch between 12 hours and 24 hours. To reset clock, press L & R at the same time ( as following b. ); after 3 seconds, clock will stop blinking automatically. After choosing 12 or 24 hours, press L & R at the same time, minutes "MM" will blink (fig. Advance them rapidly by holding the R button, or one at a time by pressing the R button (to go backward hold or press the L button). At the correct number press both L & R buttons to confirm. Follow the same method to adjust hour "HH" to complete the whole setting. Press R button to move to other display modes after clock is set. fig 5 b. Resetting clock time Test Mount the computer in the bracket. Lift the front wheel off the ground and spin the wheel checking if current speed is displayed. If not, adjust positions of wheel magnet and fork sensor as described in installation steps 7-8. Refer to the following steps for the operation of your sensor computer. Installation 1. Use the attached rubber pad between the bracket and handlebar to provide a secure fit. Slide the zip tie into bracket, position the bracket to the handlebar on either side or the stem. Cut the excess zip tie off. Page 4 Page 5 Display Functions Speed Minimal display unit 0-30km/h 0. 1km/h(mile/h) 31-60km/h 0. 5km/h(mile/h) over 60 m/h 1km/h(mile/h) Riding time ( 0:00:00-99:59:59) -- RT The Elapsed Time is measured from the start point to the current point. It starts counting automatically when signals are received, it stops when signals have stopped for over two seconds. When 10 hours have been reached, screen will display "HH" hr & "MM:SS" alternative for 1 second. When 100 hours have been reached, it will be recounted from zero. [. . . ] The last mode in use will disappear and be saved. The time will display automatically as fig. The Current Speed/Odometer mode will resume once any button is pressed or you begin pedaling. Auto Clear/Reset Under any display mode, press L & R buttons for 10 seconds, km or Mile will flash quickly, then all data stored in memory will be erased except Odometer data. All displays will illuminate for 1 second, then the km/h symbol displayed alone. [. . . ]