User manual TRENDNET TEM100-56R

[. . . ] The driver will be installed automatically, and system may ask for the Windows 95 installation CD disks to update the 3 existing files or drivers. After the update, system will reboot automatically. 4. For the first time installation, click Network icon in Control Panel to correctly add Protocols, Client and Service according to your application requirements. 5. Reboot the machine and the card will fully function. 1. 2. 2. Working with Windows 98 1. [. . . ] Give appropriate system resources to the 10/100 Fast Ethernet + 56K Fax/Modem PC Card; the settings must be unique for this device. Refer to "Resources Recommendation" for NT 3. 51 details Press OK when all setting are completed. Press CLOSE to complete NETWORK setting Reboot Windows NT. Open MY COMPUTER CONTROL PANEL MODEMS 2. Using default settings and press NEXT 3. System should have detected your DirectPort PC Card, and enter the Modem Manufactures & Models list screen. Press FINISH and then CLOSE to complete modem setting. The installations for both LAN and Modem are completed. 7 Apple/Macintoch Your Integrated PC card can also allow you run Apple/Macintoch palteform. Please follow the below procedure carefully to get your PC Card up and running. System Requirements In order to let your PC Card perform at more efficient speed, please check your system to meet the following requirement: For the following PowerBooks, it requires System7. 5. 1 or later: PowerBook 1400, or PowerBook 5300 For the following PowerBooks, it requires System 7. 6. 1or later: PowerBook 2400, PowerBook 3400, or G3. 8 MB of RAM installed for System 7. 5 or 16 MB for Systems 7. 5 4 MB of available hard drive space Driver Installation Please follow the following procedure to install the MAC driver: 8 Important Note: Please disable any virusprotection application before you installing the Modem Driver. Turn on your PowerBook computer Insert your Integrated PC Card Driver disk into your floppy disk drive Double-click the "Installer Icon" on the driver disk Click "Install" to install the driver into your hard drive Click "Restart" to re-boot your PowerBook Now you are ready to use your Integrated PC Card with your Apple Power Book. 9 FCC Certification 10/100 Fast Ethernet + 56K Fax/Modem PC Card FCC ID: MQ4PLM56 Made in Taiwan The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of modems and other electronic equipment. FCC Part 68 Registration This high speed 10/100 Fast Ethernet + 56K FAX/MODEM PC Card complies with FCC Part 68 rules, and the use of this modem is subject to the following restrictions: 1. The FCC has established rules which permit this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or coin phones. If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is not done, the telephone company may temporarily disconnect service. The telephone company may make changes in it's facilities, equipment, operation and procedures; if such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the situation with the FCC. If the telephone company requests information on what equipment is connected to their lines, inform them of: a. The telephone number to which this unit is connected. Items (b) and (d) are indicated on the label. [. . . ] (2) Consult an experienced radio/TV technician for help. CTR 21 pan-European Certification This equipment has been approved in accordance with Council Decision 98/482/EC for pan-European single terminal connection to the public switched telephone network (PSTN). However, due to differences between the individual PSTNs provided in different countries, the approval does not, of itself, give an unconditional assurance of successful operation on every PSTN network termination point. In the event of problems, you should contact your equipment supplier in the first instance. This device is designed to work with the notified networks in all EC member states. [. . . ]