User manual TRENDNET TPE-101I QUICK INSTALLATION GUIDE

[. . . ] 3 Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Jumper Cable (TPE-102S) Note: The TPE-101I and TPE-102S only support Power over Ethernet (PoE) devices that follow the IEEE 802. 3af standard Note: The TPE-102S only supports non-PoE devices with an output power of 5V, 7. 5V, 9V or 12V. Front Panel TPE-101I Power Lights green when the power cord is connected into an outlet and the PoE device is connected to the Injector. TPE-102S POWER Lights green when a PoE device is connected to the splitter. 1 English Application Power over Ethernet Injector (TPE-101I) Power Power + Data (PoE) Data Power Jack PoE Device 8-Port 10/100Mbps Fast Ethernet Switch (TE100-S8) Power Data Power + Data Power over Ethernet Injector (TPE-101I) Power Data Power Jack Power + Data (PoE) 8-Port 10/100Mbps Fast Ethernet Switch (TE100-S8) Data Power 5V/7. 5V/9V/12V DC Power Data Power + Data 5V/7. 5V/9V/12V Power Power over Ethernet Splitter (TPE-102S) Non-PoE Device which uses 5V/7. 5V/9V/12V Power Input Power over Ethernet Splitter (TPE-102S) Power + Data (PoE) PoE Switch (TPE-S44) Data 5V/7. 5V/9V/12V Power Data Power + Data 5V/7. 5V/9V/12V Power Non-PoE Device which uses 5V/7. 5V/9V/12V Power Input Power Data Power Jack Power + Data (PoE) Power over Ethernet Injector (TPE-101I) 8-Port 10/100Mbps Fast Ethernet Switch (TE100-S8) Power over Ethernet Splitter (TPE-102S) Power 5V/7. 5V/9V/12V Power Data Power + Data Data 5V/7. 5V/9V/12V Power Non-PoE Device which uses 5V/7. 5V/9V/12V Power Input 2 English 2. [. . . ] Q3: Will the TPE-101I work with any PoE device?A3: Any PoE device that follows the IEEE 802. 3af standard will work with TPE-101I. Q4: Will the TPE-102S work with any non-PoE device?A4: Non-PoE devices such as access points will work with the TPE-102S only if the non-PoE device operates at 5V, 7. 5V, 9V or 12V. Q5: I connected my non-PoE device into the TPE-102S, but my switch does not recognize the device. A5: Power cycle the non-PoE device by either pulling out the power adapter connector from the PoE injector or disconnecting the CAT 5 cable from the PoE Out port. Reinsert the connection after 5-10 seconds have elapsed. If you still encounter problems or have any questions regarding the PoE Injector/Splitter, please contact TRENDnet's Technical Support Department. 6 Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. TPE-101I/TPE-102S - 5 Year Warranty If a product does not operate as warranted above during the applicable warranty period, TRENDnet shall, at its option and expense, repair the defective product or deliver to customer an equivalent product to replace the defective item. All products that are replaced will become the property of TRENDnet. Replacement products may be new or reconditioned. TRENDnet shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated with any products returned to TRENDnet pursuant to any warranty. There are no user serviceable parts inside the product. Do not remove or attempt to service the product through any unauthorized service center. [. . . ] SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. ADVERTENCIA EN CASO DE REQUERIR AC ADAPTER En todos nuestros equipos se mencionan claramente las caracteris-ticas del adaptador de alimentacón necesario para su funcionamiento El uso de un adaptador distinto al mencionado puede producir daños fisicos y/o daños al equipo conectado. TRENDnet Technical Support US . Canada Toll Free Telephone: 1(866) 845-3673 24/7 Tech Support Europe (Germany . [. . . ]