User manual TRENDNET TU-ET10

[. . . ] TRENDnet TU-ET10 Universal Serial Bus Ethernet Adapter USER's Guide FCC Certification Part 15, Class B FCC ID: MQ4USB10TA The United States Federal Communication Commission (FCC) and the Canadian Department of Communications have established certain rules governing the use of modems and other electronic equipment. FCC Part 15 Registration This modem complies with Part 15 of FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interface, and 2) this device must accept any interface received, including interface that may cause undesired operation. [. . . ] Otherwise, please STOP this installation. Hardware Recognition To properly install the USB LAN adapter, it is very important to recognize the USB hardware. 1. USB Cable USB cable has two ends ­ One has rectangular plug, or called A-Type connector; another one has a square plug, or called B-type connector. 2. USB LAN Adapter USB LAN adapter has two ports. One port is USB B-type port and the other is RJ45 Networking port ­ it looks like an over-sized phone jack. Hardware Installation Procedure ­ Step 1 -- Make sure the PC is powered on and run Windows 98. Step 2 -- Connect cable B-type plug into adapter's B-type port. Step 3 ­ Insert USB A-type cable into the PC's USB port. Step 4 ­ Connect the adapter to a 10Mbps or 10Mbps/100Mbps auto-sensing HUB. Before you go any further, please note that your USB LAN adapter can ONLY work with Windows 98. If you don't have Windows 98 installed, please STOP now. Windows 98 Setup Note: Before you begin the driver installation, please make sure disable any network card currently installed into your system. And, have your Windows 98 CD-ROM copy handy. [. . . ] After that the system restart your computer to let the setting be permanent. LED Indicator Link: Indicates a good linkage between the ALN adapter and supporting HUB or Switch Activity (Tx/Rx): Flash when data is transmitting between network. Specifications Network Specification IEEE 802. 3 10BaseT Ethernet Cat 3/Cat 5 UTP, 100ohm STP cable up to 328ft/100M Host Interface Bus-powered from USB host or HUB, no external power needed High speed upstream B type USB port Suspend power saving mode supported Data Speed 10Mbps for Ethernet data transfer Environment Operating Ranges Temperature: 32 to 149F (0 to 65 C) Humidity: 10% to 90% noncondensing Power Consumption Operating: +5V DC. 75mA Max LED Indictor Link status ­ Green Activity (TX/RX) ­ Amber Driver Support Windows 98 Windows 2000 (when available) EMI Conformance · FCC Part 15 Class B · CE Mark Class B · Japan VCCI Class B [. . . ]