User manual TRENDNET TV-IP100W-N

[. . . ] TABLE OF CONTENTS ABOUT THIS GUIDE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 FEATURES AND BENEFITS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 UNPACKING THE PACKAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 10 Key Lock Button 11 Power Button Click to lock/unlock the camera. When locked, the user cannot operate any camera. Click to exit or minimize IPView Pro. 12 Record Button Record video clip of the selected camera and save it in the computer. The storage position can be configured in System Configuration. When you click the button, you can select Manual Record, Schedule Record, or Motion Record. 13 Play Button Play the recorded video file in the computer. Click to enter the System Configuration. 14 System Configuration 73 Using IPView Pro Adding a Camera To add a camera: 1. Click the System Configuration button to enter the System Configuration. If you are not sure of the camera's IP address, you can click Search to search the available camera(s) within the network. 74 2. Select the camera you want by highlighting it, and then click Add Camera. The camera is added. Click the Add Camera button. The camera found within the network. 3. Click Save, and then click the System Configuration button to return to View Window. The selected camera's video will be displayed now. You can click Save as to save the selected cameras into the desired path and the selected cameras can be reloaded by load button. 75 Alternately, you can add a camera by entering the its IP address directly: 4. Select the Input IP tab. The camera is added. Click the Add Camera button. Enter the camera's IP address and Port. 5. Enter the camera's IP address (default: 192. 168. 10. 30) and Port (default: 80), and then click Add Camera. Click Save, and then click the System Configuration button to return to View Window. The selected camera's video will be displayed now. 76 Removing a Camera To remove the camera from the list: 1. Click Delete Camera. 77 Viewing a Camera From the View Modes of the panel, you can select one-camera mode or other modes to display your video. IPView Pro allows a maximum of 16 cameras for viewing. For example, if you use only one camera, select one-camera mode ( ), and the View Window will display the view as figure 1. If there are four cameras, select four-camera mode ( ), and the View Window will display the view as figure 2. Figure 1 Figure 2 78 Recording Video IPView Pro allows you to record the video clip and save it in your computer through the following methods: Manual Record, Schedule Record, and Motion Record. [. . . ] It consists of several pairs of wires enclosed in an unshielded sheath. User Name Utility UTP W WAN Wide-Area Network. A wide-area network consists of groups of interconnected computers that are separated by a wide distance and communicate with each other via common carrier telecommunication techniques. Windows is a graphical user interface for workstations that use DOS. Windows Workgroup A workgroup is a group of users who are physically located together and connected to the same LAN, or a group of users who are scattered throughout an organization but are logically connected by work and are connected to the same network group. Workstation refers to the intelligent computer on the user's desktop. [. . . ]