User manual TRIMBLE AGGPS EZ-GUIDE SL SUPPORT NOTE

[. . . ] Swap the lightbar cable (PN 35204 or PN 46441). Swap the lightbar. One of the system components is faulty. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. www. trimble. com © 2003, Trimble Navigation Limited. Trimble, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States Patent & Trademark Office. [. . . ] Trimble, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States Patent & Trademark Office. The Globe & Triangle logo, and EZ-Guide are trademarks of Trimble Navigation Limited. All other trademarks are the property of their respective owners. This document is for informational purposes only. Trimble makes no warranties, expressed or implied, in this document. Page 2 of 5 AgGPS EZ-GuideTM SL ® Agriculture Problem Possible cause/s Solution/s The lightbar displays NO HOST or NO COMMS and will not provide guidance. The lightbar and AgGPS 110 are not communicating properly. Wait for about one minute to see if the problem resolves itself. Ensure that Port B is outputting LBAR protocol at 38. 4K 8-N-1, and that the correct serial port is connected to the lightbar. Remove and re-apply power to the whole system. Make sure the correct cable connector is attached to lightbar. Each connector on the cable is labeled with a white tag that shows where it should be attached. Try swapping out items such as the cable, the smart antenna, and the lightbar, to identify any faulty equipment. The lightbar displays the message INV GPS. The receiver is not outputting the right messages. Ensure that Port B is outputting LBAR protocol at 38. 4K 8-N-1, and that the correct serial port is connected to the lightbar. If you have two cables (PN 40947 and PN 35204), make sure that they are connected together according to the diagram in the EZ-Guide Quick Reference. The lightbar says MAX PTS when I try to add an area point. You are trying to add too many points. EZGuide can store a maximum of 99 area points when defining an area or custom endzone boundary. The alarm is not connected correctly. Clear the area and define it again, adding fewer points. The alarm does not sound when I expect it to. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. www. trimble. com Verify that the alarm is connected correctly to the lightbar cable (PN 46441or PN 35204). The alarm connects to the black and white cable pair that extends from the end marked "TO AgGPS RECEIVER". This cable pair may be terminated by a small rubber cap, which should be removed. Connect the white cable to the + terminal and the black cable to the ­ terminal on the alarm. © 2003, Trimble Navigation Limited. Trimble, and AgGPS are trademarks of Trimble Navigation Limited, registered in the United States Patent & Trademark Office. The Globe & Triangle logo, and EZ-Guide are trademarks of Trimble Navigation Limited. All other trademarks are the property of their respective owners. This document is for informational purposes only. [. . . ] Trimble makes no warranties, expressed or implied, in this document. Page 4 of 5 AgGPS EZ-GuideTM SL ® Agriculture Problem Possible cause/s Solution/s The alarm and approach LED does not respond at endzone boundaries. By default, the orange warning approach LED is not displayed when HLNDWARN=0. This is the default. Increase the value of HLNDWARN to a value greater than 0. Trimble Navigation Limited Agriculture Business Unit 9290 Bond Street, Suite 102 Overland Park, KS 66214 U. S. A. www. trimble. com © 2003, Trimble Navigation Limited. [. . . ]