User manual TRIMBLE AGGPS EZ-GUIDE SL 1.70 RELEASE NOTES REV A

[. . . ] It applies to version 1. 70 of the AgGPS firmware. The following limited warranties give you specific legal rights. You may have others, which vary from state/jurisdiction to state/jurisdiction. Hardware Limited Warranty Trimble Navigation Limited warrants that this hardware product (the "Product") will perform substantially in accordance with published specifications and be substantially free of defects in material and workmanship for a period of one (1) year starting from the date of delivery. The warranty set forth in this paragraph shall not apply to software products. Software License, Limited Warranty This Trimble software product, whether provided as a standalone computer software product, built into hardware circuitry as firmware, embedded in flash memory, or stored on magnetic or other media, (the "Software") is licensed and not sold, and its use is governed by the terms of the relevant End User License Agreement ("EULA") included with the Software. [. . . ] When this pattern is selected, AgGPS EZ-Guide SL maps headland circuits as you drive the field, see Figure 3. You can map as many headland circuits as necessary. B A Figure 3 Headlands pattern When mapping the headland, press b+a to start the headland. After the headland is completed, press b+a to set the A point and press a to set the B point for parallel swath guidance. AgGPS EZ-Guide SL Lightbar Guidance System Release Notes 5 You can also use the headlands pattern to complete the field with spiral guidance, see Figure 4. c c c b+ a Figure 4 Spiral guidance To use the headlands pattern, press b+d to reset guidance, and then choose NEWHLND. B 0. 2. 2 Tip ­ To change the pattern option, press c. New configuration options The following are new configuration options: · HLNDWARN ­ Configures the headland warning option. This value defaults to 0 ft or 0 m, so that the orange LED is not displayed and the headland warning alarm does not sound. · LED MODE ­ Configures the LED mode. You can set this to either CHASE or PULL lights. When the LED MODE is set to CHASE, you drive towards the lights. When it is set to PULL, you steer away from the lights. DGPS SRC ­ Configures the differential source option. · 6 AgGPS EZ-Guide SL Lightbar Guidance System Release Notes · BMOFFSET ­ Configures the boom to antenna offset front or rear. This ensures that the offline LEDs and approach LED work relative to the boom, not the antenna. · LANGUAGE ­ Configures the language to Spanish, Portuguese, or English. 0. 2. 3 Other changes Other changes to AgGPS EZ-Guide SL include: · · · · WARNDIST option has been renamed to XTE_WARN. The most commonly used menu options are easier to access. The LED Spacing default value has changed from 1 ft 6 in to 1 ft. The XTE_WARN default value has changed from 5 ft to 0 ft. This means that by default, the XTE warning alarm does not sound. With the A-B and A+ patterns, you can still map a headland manually using the area points function. Trimble recommends that you use the new Headland pattern. With the Curve and Headland patterns, the area points that you add are only used to calculate acreage. They do not create a closed-circuit headland. [. . . ] Start an Internet browser, and in the address line, type http://www. trimble. com/aggps_ezguide. html. Click Support and once the Support page appears, click Downloads. 8 AgGPS EZ-Guide SL Lightbar Guidance System Release Notes 3. Select the V1. 70 AgGPS Receiver Firmware link. 6. Select the Save this program to disk option and click OK. Save the file to a folder on the computer. Once the file has been downloaded, go to the folder where you have saved the file and double-click the file. [. . . ]