User manual TRIMBLE TERRASYNC 2.51 RELEASE NOTES REV A

[. . . ] TerraSyncTM software Release Notes Introduction What's New?Product Information Registering the TerraSync Software Installation on a CE Device Installation on a PC Cabling Known Issues Technical Assistance Version 2. 51 Revision A July 2005 Contact Information Trimble Navigation Limited Mapping & GIS Division 7401 Church Ranch Blvd Westminster, CO 80021 USA www. trimble. com Copyright and Trademarks © 2000­2005, Trimble Navigation Limited. For STL support, the TerraSync software uses the Moscow Center for SPARC Technology adaptation of the SGI Standard Template Library. © 1994 Hewlett-Packard Company, © 1996, 97 Silicon Graphics Computer Systems, Inc. , © 1997 Moscow Center for SPARC Technology. [. . . ] For information on how to do this, refer to the documentation for the CE device. Tip ­ Ensure that the CE device is configured to connect at the maximum baud rate available. 18 TerraSync Software Release Notes When the two computers are connected, the Microsoft ActiveSync window appears. The message Connected is displayed: 4. 8. Make sure that the TerraSync software is not running on the CE device. Insert the TerraSync Software CD in the CD drive of the office computer. If this screen does not appear, run setup. exe from the CD drive folder. Select the Install on Pocket PC or CE device option. TerraSync Software Release Notes 19 9. The TerraSync software installation wizard appears: 10. Follow the instructions on the screen to install the TerraSync software. You will need to enter your installation serial number, which you can obtain by registering your copy of the software. For more information, see Registering the TerraSync Software, page 14. If the message Trimble TerraSync" is already installed. Do you want to proceed with the re-install/upgrade?When the message Install Trimble TerraSync" using the default application install directory?appears, click Yes to install the software to the default location. If the CE device has a non-volatile "internal" secondary storage location, this is used as the default installation location, even if you choose to install to main memory. Internal secondary storage locations include the Disk on a GeoExplorer series handheld and the Built-In Storage on a Trimble Recon handheld. If the device has no secondary storage, or only has removable secondary storage such as a CompactFlash card, the default installation location is the main memory (RAM). 20 TerraSync Software Release Notes 13. If you clicked No in Step 12, the Select Destination Media dialog appears. Click OK to proceed with the installation. 14. Respond to any messages that appear: ­ If a message appears on the CE device stating that the TerraSync software is already installed, and asking if you want to reinstall the TerraSync software, tap Yes. If the message Confirm ignore missing file appears on the CE device, tap Yes to All. If the message Install "Trimble TerraSync" to \Disk\Trimble TerraSync\ ? [. . . ] When you install the TerraSync software on a GeoExplorer series handheld, some settings are stored in the main memory, even though the TerraSync software is always installed to the Disk. To protect these settings, the TerraSync software installation program automatically backs up the main memory after installing the TerraSync software. To avoid data loss, Trimble recommends that you also back up the main memory immediately after making any changes to system settings. For information on backing up the main memory, refer to the GeoExplorer Series Getting Started Guide. · When using a GeoExplorer series handheld as an external GPS receiver, with a cabled connection from your field computer to the serial clip on the GeoExplorer series handheld, the only baud rate that is supported is 38400. [. . . ]