User manual TRIMBLE TOTAL CONTROL 2.73 RELEASE NOTES

[. . . ] 4, 558, 302 or material copyright © 1987 by the Software Development Group, University of Waterloo, Ontario or material licensed from the UK Defence and Evaluation Research Agency, Crown Copyright© 1995. Trimble is a trademark of Trimble Navigation Limited, registered in the United States Patent and Trademark Office. The Globe & Triangle logo, Trimble Survey Controller, Trimble Total Control, and VRS, are trademarks of Trimble Navigation Limited. [. . . ] The following limited warranties give you specific legal rights. You may have others, which vary from state/jurisdiction to state/jurisdiction. Software License, Limited Warranty This Trimble software product, whether provided as a standalone computer software product, built into hardware circuitry as firmware, embedded in flash memory, or stored on magnetic or other media, (the "Software") is licensed and not sold, and its use is governed by the terms of the relevant End User License Agreement ("EULA") included with the Software. In the absence of a separate EULA included with the Software providing different limited warranty terms, exclusions and limitations, the following terms and conditions shall apply. Trimble warrants that this Trimble Software product will substantially conform to Trimble's applicable published specifications for the Software for a period of ninety (90) days, starting from the date of delivery. Limitation of Liability TRIMBLE'S ENTIRE LIABILITY UNDER ANY PROVISION HEREIN SHALL BE LIMITED TO THE AMOUNT PAID BY YOU FOR THE PRODUCT OR SOFTWARE LICENSE. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL TRIMBLE OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES WHATSOEVER UNDER ANY CIRCUMSTANCE OR LEGAL THEORY RELATING IN ANY WAY TO THE PRODUCTS, SOFTWARE AND ACCOMPANYING DOCUMENTATION AND MATERIALS, (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, OR ANY OTHER PECUNIARY LOSS), REGARDLESS WHETHER TRIMBLE HAS BEEN ADVISED OF THE POSSIBILITY OF ANY SUCH LOSS AND REGARDLESS OF THE COURSE OF DEALING WHICH DEVELOPS OR HAS DEVELOPED BETWEEN YOU AND TRIMBLE. BECAUSE SOME STATES AND JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, THE ABOVE LIMITATION MAY NOT APPLY TO YOU. NOT WITHSTANDING THE ABOVE, IF YOU PURCHASED THIS PRODUCT OR SOFTWARE IN THE EUROPEAN UNION, THE ABOVE WARRANTY PROVISIONS MAY NOT APPLY. PLEASE CONTACT YOUR DEALER FOR APPLICABLE WARRANTY INFORMATION. Warranty Remedies Trimble's sole liability and your exclusive remedy under the warranties set forth above shall be, at Trimble's option, to repair or replace any Product or Software that fails to conform to such warranty ("Nonconforming Product") or refund the purchase price paid by you for any such Nonconforming Product, upon your return of any Nonconforming Product to Trimble in accordance with Trimble's standard return material authorization procedures. Warranty Exclusions and Disclaimer These warranties shall be applied only in the event and to the extent that (i) the Products and Software are properly and correctly installed, configured, interfaced, maintained, stored, and operated in accordance with Trimble's relevant operator's manual and specifications, and; (ii) the Products 0. 1 Introduction This document describes changes made to the Trimble Total ControlTM software since version 2. 70 was released. This 2. 73 update contains all improvements made since version 2. 70 was released. Trimble recommends that if you have Trimble Total Control version 2. 70, 2. 71, or 2. 72 that you update to version 2. 73. 0. 2 New Features and Changes The following changes have been made to the Trimble Total Control software for all users since version 2. 70: · · · · · · · · · · · Recomputation tolerance flags are now displayed. Recomputation now uses starting coordinates from imported files. Trimble DAT file import of antenna, point name, point code, and receiver information is improved. Baseline Processing reports now show all data for all satellites. Postprocessed VRSTM (Virtual Reference Station) files now contain reference satellite information. GPS site calibration is improved and the Remove Site Calibration functionality has been enhanced. Trimble Survey ControllerTM 10. 7 software files are now supported. [. . . ] Click Support / Downloads / Trimble Total Control Version 2. 73). Click the link of the language of the software that you need. Make sure you upgrade the software in the same language as that of your 2. 7x software. [. . . ]