User manual TRISTAR CM-2276

[. . . ] By ignoring the safety instructions the manufacturer cannot be held responsible for the damage. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Never move the appliance by pulling the cord and make sure the cord cannot become entangled. The appliance must be placed on a stable, level surface. [. . . ] Select the desired filter and fit into the filter holder. use the smaller filter For making one cup of coffee and the larger filter for 2 cups. Add the coffee using the measuring spoon provided one full spoon per Cup, level the surface then lightly press with the tamper of the measuring spoon, wipe off any coffee around the rim. When buying ground coffee make sure it is suitable for espresso machines. Never press the coffee too firmly as the coffee will come out slowly and the cream will be of a dark colour, however, if it is pressed too lightly , the coffee will come out too fast and the cream will be a light colour. Attach the filter holder into the appliance, turn it to the right to lock into position. Pour out the hot water in the cup that you used for preheating. Ensure the on/off switch is on, the green lamp will be illuminated. When you've enough coffee, not too much otherwise it will be too weak (optimum dosage is 30ml per cup) manually press the coffee pump button again. If you are not making any more coffee, press the on/off switch to turn off the appliance. Remove the filter holder by turning to the left. There will be water on the filter when you remove it, this is normal. To remove the used coffee from the filter holder, please lift the plastic pressing block to press the edge of filter, then tip the filter holder upside down and tap out the grounds. Note: During operation, it is normal that the ready indicator is likely to extinguish, it only means that the heater is heating up to keep the temperature at the standard range. Important: Do not leave the coffee maker unattended during brewing, it sometimes requires manual operation. Press down the Steam button, wait until the green indicator is Illuminated, this indicates that the boiler has reached the correct temperature. Partly fill a jug with milk - the milk may increase up to three times in volume so select a suitably sized jug. Cold semi skimmed milk gives the best results. In order to get the best result, it is recommended to release some steam before putting the nozzle in the milk. Turn the steam control knob to the left and hold it for 15 seconds, then turn it back to the `/ ` position. Position the jug under the steam nozzle. Place the nozzle into the milk about 20mm deep and turn the steam control knob in an anticlockwise direction, the milk will begin to increase in volume and appear frothy. [. . . ] descaling · The appliance has to be descaled every month, otherwise the coffee Taste will become bad and the scale deposited inside in the machine may cause permanent and irreparable damage to the machine. In case of using solid descaler, make sure the descaler dissolves into cold water fully before pouring into the water tank. These descalers may damage your machine. Mix adequate descaling agent with cold water in a measuring jug as per its instructions. [. . . ]