User manual TRONIC KH 3002 MOBILE POWER SUPPLY

[. . . ] Power supply over the low voltage socket (max. Power supply over the 10 amp socket (Vehicle power plug) Power supply over the screw connections Carrying out connections using the banana plugs. 44 Carrying out connections with the bare ends of fixed appliance cables . 44 Carrying out connections over a loose cable . [. . . ] place the main switch 2 in the "OFF" position (centre position). In this way you can avoid damage through connection faults. Should the adapter plugs be connected with opposite markings (+ and -) on the adapter cable , then on the adapter plugs positive is outside and negative is inside. Now you can withdraw the adapter cable plugs from both the appliance and the Energy Station. If neither of the two LEDs, 5 and 6, light up after switching on, then the 10 amp fuse 8 on the Energy Station might have blown. Should an LED light up on the Energy Station after switching on, but the appliance fails to work, immediately switch the Energy Station off. check to ensure that the cable is correctly connected ­ and "Positive" and "Negative" have not been switched. If required, also check the fuse in your appliance, as described in its operating instructions. For as long as sufficient energy is available for the appliance being supplied, the green LED "Full" 5 is illuminated in the OUTPUT field. When there no longer sufficient energy available for the appliance being supplied, the red LED "Empty" 5 is illuminated in the OUTPUT field. You must first recharge the battery when the red LED "Empty" 5 is illuminated. Otherwise the battery will be depleted, usually resulting in a considerable loss of charging capacity. Switch the appliance off that is being supplied with power. In this way you prevent current flowing while the connector is being withdrawn. Power supply over the 10 amp socket (Vehicle power plug) caution!Before performing any connections, always check to ensure that both the appliance to be supplied and the Energy Station are switched off. place the main switch 2 in the "OFF" position (centre position). In this way you can avoid damage through connection faults. Please bear in mind that with a 10 A load the battery will be exhausted after not more than 45 minutes ­ subject to the battery charge condition, even earlier. cooler boxes have a typical power consumption of 3 - 4 A per hour. With a battery capacity of 7 Ah, this corresponds to just under 2 hours of operating time. You can roughly estimate the operating time for your appliance using this calculation example. [. . . ] Pull out the flat fuse 8 at the rear of your appliance (e. Because of the natural self-discharge of batteries, the Energy Station should be fully charged once more before putting it into storage for several days or weeks. If you wish to store the appliance for an extended period of time without usage, to prevent a full depletion of the battery it should be recharged before the expiry of 6 months. Disconnect all cable connections between the Energy Station and any appliances that might be connected to it. [. . . ]