User manual TRONIC KH 6900 AUTOMATIC PET FEEDER

[. . . ] For this reason, never put water into any of the four food chambers. Only ever use the insert provided for this with the appliance. With old batteries in particular, battery leaks may occur. For this reason, always remove the batteries when you are not using the automatic pet feeder for longer periods of time. [. . . ] Then remove the lid from the automatic pet feeder. Remove the cover with water dish · from the automatic pet feeder. Now fill the food chambers with wet or dry food. You can add food for up to four feedings. The pins on the bottom side of the cover must fit into the holes on the inner edge of the casing ². Now place the lid back on the automatic pet feeder. The pins on the bottom side of the lid must fit into the holes on the outer edge of the casing ². Press carefully on the lid until it rests firmly. Do not apply force when doing so, otherwise it may be damaged. Note: At the programmed feeding times, the food chambers open in the order of the numbering. · program only a single feeding: Add the food to chamber 1. · program only two feedings: Add food to chambers 1 and 2. · program only three feedings: Add food to chambers 1 to 3. If you would also like to provide water in addition to food, leave the lid ³ off the automatic pet feeder. Add water to the insert in the cover ·. You also have the option of inserting typical wet food portion-sized dishes into one of the food chambers. To do this, use rectangular wet food portion-sized dishes (e. g. Lidl Coshida) and the adapter for wet food portion-sized dishes ¿. Inserting a portion-sized dish into the automatic pet feeder: Slide the cover flap » for the food chambers back to its original position. Place the cover with water dish · back on the automatic pet feeder. Remove the lid of the portion-sized dish. Slide the portion-sized dish into the adapter for wet food portion-sized dishes ¿ as shown in Fig. Insert the adapter ¿ including portion-sized dish into food chamber 1 (see Fig. 3). -7- KH 6900 Programming feeding times 1. · the main switch º on the bottom side of the automatic pet feeder is set to ON and · the time has been set correctly ­ as described under "Setting the time". To program the first feeding: Press the MODE button once. [. . . ] Then place them back into the casing ² in their original positions. Set the main switch º on the bottom side of the automatic pet feeder back to ON. -9- KH 6900 Disposal Do not dispose of the automatic pet feeder in household waste. Contact the office of your city or community responsible for waste disposal and management. Ask there what opportunities exist or are required for disposal of electronic devices. [. . . ]