User manual TRONIC TLG 500 A1

[. . . ] There would then be the danger of receiving an electric shock and or causing a fire!· Only charge rechargable batteries of the types , , Ni-Cd" and , , Ni-MH". NEVER recharge batteries of other types or non-rechargable batteries. Batteries not suitable for recharging can overheat and explode. [. . . ] · Place the Battery Charger on a straight, level, scratch and slip resistant surface. Notice: Ensure that the batteries are inserted into the charging slots in accordance with their polarities. Otherwise, the batteries will not be charged. · Insert the batteries into the charging slots. · Press the 9 V Block batteries into the charging slot until they audibly engage. Between 1-6 batteries can be loaded individually: · 4 x Type C or Type D in the charging slots 1 to 4, or · 4 x Type AA or AAA in the charging slots 1 to 4, with additionally 2 x Type 9 Volt Block batteries in the charging slots 5 and 6. · The charging process now begins. The Battery Charger has an LED for each charging slot. The LEDs of the charging slots indicate the charge state of the battery they contain. · In the first 5 seconds, the Battery Charger performs a quick capacity test: - The LED of the charging slot glows green: Capacity over 90 %. - The LED of the charging slot blinks green: Capacity between 80 % - 90 %. - The charging bay LED lights up red: The capacity is between 70 % - 80 % - The charging bay LED blinks red: The capacity is under 70 %. Notice: This appliance is equipped with non-slip rubber feet. As furniture surfaces may be made of a variety of materials and are treated with many different types of cleaning agents, it cannot be completely ruled out that some substances contain ingredients which may corrode the rubber feet and soften them. If possible, place an anti-slip material under the device. · Compare the technical data with that of your current mains power supplier. If they are the same, connect the power cable to a mains power socket. The Battery Charger is now ready for use. Charging batteries Danger! Charge exclusively rechargable batteries of the types , , Ni-Cd" and , , Ni-MH". NEVER recharge batteries of other types or nonrechargable batteries. They could irreparably damage the Battery Charger and the inserted batteries. There is also the danger of a fire as well as an explosion! Notice: If the charging bay LED blinks red for longer than 5 seconds the rechargeable battery is not correctly inserted into the charging bay or the battery is defective. When the capacity of the battery is determined, charging process starts. -4- The various indicators have the following meanings: - The LED blinks red and green every second (Not for 9V Block batteries): The rechargeable batteries are alternately charged and discharged. . (Refresh-Function: Older batteries or those that have been stored for a long period will be refreshed. ). The LED flashes red and green in a 1/2 second rhythm (not applicable to 9V rechargeable batteries): If the rechargeable batteries do not have to be refreshed (refresh function), conditional on the length of storage or the age, the following process takes place: the rechargeable batteries are discharged to minimize the memory effect. [. . . ] Instead, use a soft and clean brush to clean the insides. DO NOT use abrasive or chemical cleaning agents. The inserted batteries are not being charged · Check that the batteries are being inserted in accord with their polarity. · Check that batteries suitable for charging have been inserted into the Battery Charger. Suitable for charging are exclusively rechargable Ni-Cd and Ni-MH batteries of the types AAA/AA/C/D and 9 V Block batteries. [. . . ]