User manual U-LINE CLR2160BK 1-4INSERTPANEL INSTALL

[. . . ] TM Custom 1/4" Door Panel Preparation and Installation Instructions for Models 2175, 2115 and CLR2160 www. U-LineService. com Phone (414) 354-0300 · FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 · FAX (414) 354-5696 OnlineService@U-Line. com ©2006 U-Line Corporation 04/2006 TM Custom 1/4'' Door Panel Insert Door Panel Preparation A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides. IMPORTANT Raised panels will reduce the door's 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure. [. . . ] Install two small screws removed in Step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. For 2115 & CLR2160 models cut the panel insert to the following dimensions. Custom 1/4" Dimensions: Width: Height: 14-1/32" 27-11/16" The door panel must not weigh more than 20 lbs. Door Panel Installation Install the insert as follows: CAUTION Use care when handling the insert. Remove top hinge screw pin (using a Phillips screwdriver, see Figure 1). Remove door by tilting forward and lifting off bottom hinge pin. www. U-LineService. com 2 04/2006 TM Checking Door Alignment The unit's door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. IMPORTANT Properly aligned, the door should be 1/8" below the top of the unit's cabinet, NOT flush with the top (see Figure 4). Slotted Mounting Holes Notch (must face toward center of door) 1/8" Raise Outside Door Edge Lower Outside Door Edge Figure 6 3. If the top far edge of the door needs to move UP, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move DOWN, move the hinge plate toward the inside of the door and retighten screws. Mount the door to recheck alignment and repeat Steps 2 and 3 if further adjustment is necessary. When top edge of door is parallel to top edge of cabinet, remove the door and ensure the two screws are secure. Remove the door closers from the bottom hinge, clean thoroughly and lubricate the mating surfaces with petroleum jelly. Reinstall the closers, lining up the bosses with holes in hinge and hinge plate (see Figure 7). Mount the door and install top hinge pivot pin. Door Closer Inserts Figure 4 1. [. . . ] State the Model Number and Serial Number and explain the problem. The Model and Serial Number plate is located inside unit at upper right hand corner. If you need to locate a service company, you can go online at www. U-LineService. com and search for a service company by zip code. For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter icemakers, Combo® icemaker/refrigerators, Wine Captain® wine storage units, refrigerators, refrigerated drawers and refrigerator/freezers. ©2006 U-Line Corporation Publication No. [. . . ]