User manual U-LINE CLR2160PSSHL

[. . . ] Use and Care Guide Clear Ice Maker Model: CLR2160 Clear Combo® Ice Maker/Refrigerator Model: CLRCO2175 CLR2160 CLRCO2175 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world's number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. [. . . ] Refer to the following steps to initiate the self-cleaning cycle. ULIN_0059_A Figure 10 3. Remove inside front cover (Figure 10, 1). IMPORTANT · The Model CLRCO2175 refrigerator will not operate during the ice maker cleaning cycle. Remove all fresh food to prevent spoilage. · Model CLRCO2175 ice production after the first harvest may take longer after the cleaning cycle since restoring the refrigerator temperature will take precedence over ice production. Once the refrigerator reaches its set-point temperature, ice making will resume. 1 ULIN_0060_A IMPORTANT Never use anything to force ice from the evaporator. Remove the overflow tube (Figure 11, 1) by lifting it up while using a slight back and forth motion to loosen 12 CLR2160, CLRCO2175 it from the drain hole. The water in the reservoir will flow down the drain. Replace the overflow tube after all of the water has drained from the reservoir. Touch and hold the ON/OFF button (Figure 9, 1). Touch and release the LIGHT button (Figure 9, 4) three times, then release the ON/OFF button (Figure 9, 1). The display (Figure 9, 3) will show "CL" to confirm the beginning of the cleaning cycle. When water begins to flow over the evaporator (approximately three minutes), add one package of ULine Ice Machine cleaner to the water reservoir. When the self-cleaning process stops (approximately 45 minutes) the unit will remain off for an additional 15 minutes. When clean cycle is completed, display will automatically switch back to set temperature and unit will run as normal operation. Clean the storage bin (See INTERIOR CLEANING). Sanitize the bin with a solution of 1 tablespoon of bleach in 1 gallon of warm water. To ensure that the drain system is working properly, pour 1 gallon of cool, fresh water into the ice bin. If your unit is equipped with a drain pump, it should drain the ice bin. When ice production resumes, the water fill valve will energize, fill the water reservoir, and shut-off after three minutes. The compressor begins to operate and water flows over the evaporator assembly (ice cube tray). Initially, the water flow may not be uniform, causing uneven sized cubes or water to spill into the ice storage bin. This is a normal situation that will correct itself within the first 24 hours of operation. 3 2 1 Figure 12 ULIN_0061_A 4. [. . . ] Ice maker will automatically turn back on in three hours. Hold Hold NOTE: 38°F is an example; the display will vary with actual set-point. IMPORTANT Factory recommended set-point is 38°F for refrigerators and beverage centers, and 50°F for wine coolers. 22 CLR2160, CLRCO2175 U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Lines option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, ULine shall: (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. [. . . ]