User manual UFREE SCOOTER ELECTRIC SCOOTER FS-E35

[. . . ] You can always assist your scooter, especially on hills, by push kicking like a traditional push powered scooter. Please be sure to operate your scooter safely and be aware of pedestrians. Be observant of all local and state laws involving scooter usage. Pay attention to ALL SAFETY WARNING and CAUTIONS noted within this manual. [. . . ] LIFT QUICK RELEASE HANDLE ADJUSTMENT FIG. 2 HANDLEBARS Insert Grips into Handlebar T-Frame as shown in fig 3. Be sure that Snap Pins fit into, and lock the small holes in the top of the T-Frame. With the HANDLE SWITCH SNAP PINS HANDLE SWITCH handlebars in the upright & locked position, and the rider standing on the platform with ONE HAND ON THE BRAKE, adjust the Handlebar height to just below the rider's waistline. This is accomplished by loosening the Height adjuster (fig. 3) while holding onto the handlebars . . . move the handlebars to the desired height and tighten Height Adjuster. FIG. 3 GRIPS HANDLEBRAK 3 UFREE SCOOTER www. scooter-manufacturer. com ADJUSTMENTS AND OPERATION HAND OPERATED POWER SWITCH (Throttle) The Scooter is equipped with a handle Operated Power Switch located on the handlebars of the scooter (fig. When turn "on", the power is on and the motor and rear wheel causes the scooter to move forward. HANDLE OPERATED MECHANICAL BRAKE The Rear Wheel Brake is activated by clamping handle brake to the Round Brake Pedal (fig 1) located on the handlebars. This Brake is a friction brake . . . the hander you press the more braking action you will have. This Brake also has a micro switch that disconnects the power to the motor. RANGE AND SPEED When fully charged£¬ the scooter will cover approximately 30 miles on level ground with a 240 LB. Rider top speed is approximately 35 with a 240LB. NOTE -These figures are estimates only, they will vary. STEERING ADJUSTMENT NUTS, BICYCLETYPE You will need to periodically check your steering for play or looseness. The steering tightness can be adjusted by turning the ROUND HAND NUT clockwise and locking with the hex nut (fig 1) CHARGING When shipped the batteries are fully charged. Charging the Batteries after every use is recommended. For extended battery life, DO NOT discharge Batteries completely before recharging. Following this simple rule: When the starts to slow down on level ground, it's time to recharge. CHARGING PROCEDURE In order -with charger in hand, locate the Charge Socket under the scooter (fig 4). Pig the charger into the Charger Socket. Next, plug the charger into a standard 110/220 volt electrical our-lof. Charging temperature 50 to 100F DO NOT OVER-CHARGER-SEE CHART when finished unplug Charger from the wall outlet then scooter and replace cap over the charge socket. IMPORT To insure that the batteries are fully recharged before using but are not overcharged; please follow the charging times recommended. [. . . ] We suggest that you purchase additional batteries for extra power requirements. REPLACEMENT BATTERIES Even with proper care, rechargeable batteries will not last forever. When Batteries will not hold a charge, please call the LOCAL DISTRBUTOR. IMPORTANT: These batteries are Lead Acid based and must be recycled properly. [. . . ]