User manual ULINE ECHELON 2075DWRWC

[. . . ] INTRODUCTION Congratulations on your purchase of your U-Line drawer unit. A pioneer in the field for more than 40 years, U-Line is the world's number one manufacturer of built-in, under-counter ice making and specialty refrigeration products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology leads the market with innovation, design, depth of product line and performance. [. . . ] To check the actual temperature in the ice compartment, press the WARMER button momentarily, and then press and hold "COOLER" for 3 seconds. NOTE The ice compartment set temperature is 0°F and cannot be set. The temperature may vary while cycling or when the unit is in the self defrost mode. The temperature may adjust itself slightly up or down to match the refrigerator set point if it changes from 38°F. The temperature will be the air temperature and may vary between +10°F and ­10°F. During defrost or after loading product, the temperature may appear higher temporarily. Refer to Table 2 to determine indicator light status. LED 1 2 Status · Solid · Flashing · Solid · Flashing Indicates · Refrigerator Temperature displayed · Not Applicable · Freezer Temperature displayed · Open Thermistor ­ call for service Table 2. Indicator Light Status - 26 Temperature Controller DWR034 Figure 23 The temperature controls are integrated in the top, front drawer panel. They consist of an LED display and touch sensors for each drawer and a touch sensor to control the lighting (" ", " " and " "). The LED displays show the drawer's temperature set point, and are calibrated in degrees Fahrenheit. The controls are factory programmed for a set point of 60°F for the top drawer and 40° F for the bottom drawer. Each drawer's display will show its set point when the unit is first powered up. DWR045 Figure 24 To display actual temperature of each drawer, press the " " and " " touch sensors simultaneously for three seconds. The display indicates the actual temperature. After approximately 10 seconds, the set point temperature displays. 27 User's Manual To adjust the temperature set point, touch and hold either the " " or " " for that drawer for three seconds. When the LED displays "SP lift your finger from the controller and the corresponding LED , " will begin to flash the set point. Touch the " " or " " until the desired set point displays. Wait 10 seconds for the new set point to be saved. Wait 24 hours for the temperature to stabilize before checking the actual temperature again. Each wine compartment can be set to 40°F to 60°F. INTERIOR LIGHTING The interior lighting can be controlled by the controller. Each time the light " " symbol is touched, the lighting is scrolled through the following options: Touch once ­ Both compartment lights on. Touch twice ­ Top compartment light on, bottom compartment light off. Touch three times ­ Bottom compartment light on, top compartment light off. [. . . ] See MAINTENANCE. The unit is not cold enough. Water is leaking out the back of the unit. Ice cubes sticking together. Water supply connection leaking. Copper water supply tubing contacting internal components. Dirty condenser coils. Noise during operation. No ice. Not enough ice. 46 TROUBLESHOOTING (CONTINUED) Problem Fresh food section too cold. [. . . ]