User manual ULINE ECHELON CLRCO2075

[. . . ] É c h e l o nTM U S E R M A N U A L U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Line's option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, U-Line shall:. (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii)and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. [. . . ] Make sure the overflow tube (refer to Figures 37 and 38 in Maintenance) is seated properly. There is a possibility it may have loosened during shipment. Make sure the draining system is working properly and the drain hose is not pinched or kinked. Pour one gallon of cool, fresh water into the ice bin. If your CLRCO2075 is equipped with a drain pump, the pump should drain the ice bin. Open the water supply valve in the main water source. Be sure that the cycle selector switch is in the ON position. The water fill valve will energize and fill the water reservoir. The water fill valve shuts off after 180 seconds. The compressor begins to operate and water flows over the evaporator assembly (ice cube tray). Upon initial start-up, water flow over the evaporator may be uneven. This may cause uneven sized cubes or water spilling into the ice storage bin. This is a normal situation and will correct itself within the first twenty-four hours of operation. After the initial startup period, the water will cascade evenly over the evaporator. 5. 6. C L N O F F O N C L N O F F O N After the first slab of ice is produced, ice production will stop until the refrigerator side of the CLRCO2075 reaches the set point temperature. After the refrigerator reaches temperature, ice production will begin again. It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first two to three hours of operation. TEMPERATURE CONTROLLER 1 2 3 WARMER COOLER SET TEMP CLRCO011 Figure 28 The temperature controller (Figure 28) is located below the clear ice maker. It consists of an LED display, three LED status indicator lights and three touchpad buttons. The LED display shows the temperature set point and is calibrated in degrees Fahrenheit. The controller is factory programmed for a set point of 38°F which will show when the unit is first powered up. To display actual temperature in the refrigerator, press the "WARMER" button momentarily. A solid status indicator light (1, Figure 28) will show and the air temperature reading in the cabinet will show for approximately 10 seconds. [. . . ] Unit runs but no ice is produced. Temperature control set too cold. No water being supplied to the unit. 40 Problem Unit runs but produces very little ice. Possible Cause Dirty condenser coils. High air temperature around unit. Scale and mineral buildup in unit. Inadequate airflow at the front of the unit. Ice is slow to release or does not release from the evaporator. (soft or unclear) Ice-making system is dirty. Unit is not level. [. . . ]