User manual ULINE ORIGINS CO29 INSTALL GUIDE

[. . . ] Installation Guide CO29A and CO29FF Ice Maker/Refrigerators www. U-LineService. com Phone (414) 354-0300 · FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 · FAX (414) 354-5696 OnlineService@U-Line. com ©2005 U-Line Corporation 02/2005 CO29A and CO29FF Ice Maker/Refrigerators Contents Exterior Cleaning . Custom 1/4" Thick Door Panel Insert . 3 4 4 4 5 6 7 8 8 8 9 10 10 10 11 11 11 12 12 1 Follow Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install or operate the unit. · This unit requires connection to the water supply. [. . . ] Units may be installed outdoors in a covered area. The unit must not be located near heat-generating equipment or in direct sunlight. Figure 10 www. U-LineService. com 6 02/2005 CO29A and CO29FF Ice Maker/Refrigerators 4 Prepare and Install Door Panel Units will accept a Custom 1/4" Thick Insert to harmonize with or accent the surrounding decor. If this treatment is not included in this installation, go on to 5 Adjust Door. Custom 1/4" Thick Door Panel Insert Door Panel Preparation A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides. Figure 12 Figure 13 IMPORTANT Raised panels will reduce the door's 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 4). Cut the panel insert to the following dimensions. Custom 1/4" Dimensions: Width: Height: 19-13/16" 21-13/32" 2. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 13). Remove two outside screws holding door handle. Slightly separate door handle from door (see Figure 14). Slide custom door panel insert into 1/4-inch channel in door front. Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in Step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door. Figure 14 The door panel must not weigh more than 20 lbs. Door Panel Installation Install the insert as follows: CAUTION Use care when handling the insert. Remove top hinge screw pin with a Phillips head screwdriver. Remove door by tilting forward and lifting off bottom hinge pin. 02/2005 7 www. U-LineService. com CO29A and CO29FF Ice Maker/Refrigerators 5 Adjust Door 6 Prepare Plumbing CAUTION Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. Checking Door Alignment The unit's door is aligned at the factory before shipment. [. . . ] No other adjustments should be necessary at this time. For information about Adjusting the Temperature Control, see the User Manual. As soon as the ice maker mold reaches the proper temperature, the ice maker mechanism will fill the mold with water. Note: The first cubes may be small because of air in the water line. [. . . ]