User manual ULINE ORIGINS CO29FF

[. . . ] Use and Care Guide Combo® Model: CO29FF CO29FF 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world's number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. [. . . ] Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING Disconnect electric power to the unit before cleaning the condenser. 2 1 Figure 9 6. Make sure grille cap is behind grille in slots provided in grille (Figure 9, 1) before attaching grille to unit, and secure but do not overtighten both grille screws (Figure 9, 2). Reinstall the control knob (Figure 7, 1). Reconnect power to the unit. ULIN_0198_A WARNING DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. IMPORTANT DO NOT use any type of cleaner on the condenser unit. Disconnect power to the unit. Ice Maker Maintenance Inlet Screen Interval - Every Twelve Months The solenoid valve inlet screen must be cleaned at least once each year as follows: 1. Shut off the water at the main supply valve. Pull the unit out to access the back panel. 2 1 ULIN_0197_A 3. Disconnect electrical power to the unit. Figure 7 2. Remove the control knob (Figure 7, 1) by pulling it straight out, away from grille. Remove two screws from grille (Figure 7, 2) and save. Remove grille and grille cap from unit. 2 1 1 Figure 10 4. Disconnect the hose connector (Figure 10, 1) from the water solenoid valve (Figure 10, 2). ULIN_0153_A ULIN_0054_A Figure 8 5. Clean the condenser coil (Figure 8, 1) using a using a soft brush with a "combing" action or vacuum cleaner. DO NOT remove the inlet screen from the water solenoid valve. Use a tooth brush to gently clean any sediment from the inlet screen. Re-connect the water supply hose connector (Figure 10, 1) to the water solenoid valve (Figure 10, 2). Open the water main supply valve and check for leakage at the water hose connection. Ensure that the water supply line is not kinked. Reconnect power to the unit before re-installing. 10 CO29FF Ice Cube Thickness Adjustment Interval - As Required On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows: 4. Install the ice maker assembly cover. IMPORTANT Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP Whirlpool parts. [. . . ] Set control to warmer setting (See OPERATION). CO29FF 15 This page intentionally left blank 16 CO29FF This page intentionally left blank CO29FF 17 This page intentionally left blank 18 CO29FF U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one-year warranty period for all U-Line products U-Line shall: (1) at U-Lines option, repair any product or replace any part of a product that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part. During years two through five of the warranty period for the sealed system, ULine shall: (1) repair or replace any part of the sealed system that breaches this warranty; and (2) for all Marine, RV and Domestic U-Line products sold and serviced in the United States (including Alaska and Hawaii) and Canada, U-Line shall cover the labor costs incurred in connection with the replacement of any defective part of the sealed system. All other charges, including transportation charges for replacements under this warranty and labor costs not specifically covered by this warranty, shall be borne by you. [. . . ]