User manual ULINE ORIGINS WH95TP INSTALLATION GUIDE

[. . . ] Installation Guide WH95TP, BI95BTP and BCM95 Ice Makers for Marine or Recreational Vehicle Use www. U-LineService. com Phone (414) 354-0300 · FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 · FAX (414) 354-5696 OnlineService@U-Line. com ©2005 U-Line Corporation 02/2005 WH95TP, BI95BTP and BCM95 Ice Makers Contents Exterior Cleaning . Custom 1/4" Thick Door Panel Insert . Installation of the WH95TP, BI95BTP or BCM95 . 3 4 4 4 5 6 7 8 8 8 9 10 10 10 11 11 12 12 1 Follow Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install or operate the unit. [. . . ] Align door pivot hole with pivot hole in upper hinge and insert pivot screw into upper hinge and tighten securely. Tighten upper and lower hinge screws securely. Gently slide travel pin assembly through flange and then fasten Figure 13 to unit. Make sure travel pin in door engages the closer in the assembly, then tighten screws on travel pin assembly securely. See Figure 13. www. U-LineService. com 6 02/2005 WH95TP, BI95BTP and BCM95 Ice Makers 4 Prepare and Install Door Panel (BI95BTP units only) Units will accept a Custom 1/4" Thick Insert to harmonize with or accent the surrounding decor. If this treatment is not included in this installation, go on to 5 Adjust Door. Custom 1/4" Thick Door Panel Insert Door Panel Preparation A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides. Figure 14 Figure 15 IMPORTANT Raised panels will reduce the door's 90° swing/zero clearance if the unit is installed next to a wall or similar type of structure (see Page 4). Cut the panel insert to the following dimensions. Custom 1/4" Dimensions: Width: Height: 12-15/16" 13-15/32" 2. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 15). Remove two outside screws holding door handle. Slightly separate door handle from door (see Figure 16). Slide custom door panel insert into 1/4-inch channel in door front. Holding door gasket out of the way, replace handle on door, making sure it is seated properly on insert and that screw holes line up. Install two small screws removed in Step 3. Starting at the corners and working inward, push door gasket into place on door. Place door on bottom hinge pin and install upper hinge screw. Go on to 5 Adjust Door. Figure 16 The door panel must not weigh more than 20 lbs. Door Panel Installation Install the insert as follows: CAUTION Use care when handling the insert. Remove top hinge screw pin with a Phillips head screwdriver (see Figure 14). [. . . ] Identify the grille screw hole on the grille itself. It is located toward the top of the middle recessed section of the grille. Place the two hook-hinges (located on the rear bottom side of the grille) onto the front lip of the unit base. Swing the grille up into position, aligning the grille screw hole on the grille to the grille screw hole on the cabinet. [. . . ]