User manual UNIDEN DCT7585

[. . . ] Table of Contents Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Welcome. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Accessibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Terminology Used in this Manual. . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Move the cursor to PRIVACY MODE, and then press [select/ display for 2 seconds; the icon remains in the display as long as privacy mode is on. To turn privacy mode off, repeat the procedure listed above. Seven-Digit Dialing If you can make a local call by dialing only 7 digits (instead of 10), you can program your local area code in your phone. Calls that come from within your area code will show only the 7-digit phone number; calls from outside your area code will show all 10 digits. To enter an area code, follow the steps below: 1. Select the GLOBAL SETUP menu, and then the AREA CODE submenu. Use the number keypad ([0] through [9]) to enter a 3-digit area code. If an area code has already been stored, it appears in the display. Press [menu/clear] to delete the stored code, and then enter a new one. You will hear a confirmation tone. 39 Using the DirectLinkTM Communication Feature Using the DirectLink two-way communication feature, a pair of handsets can function as two-way radios. DirectLink communication does not interfere with the base's ability to make or receive telephone calls. You must set both handsets to use DirectLink communication before they can call each other. Other handsets can be used while two handsets are using DirectLink communication; however, the two handsets using DirectLink communication are not able to make or receive calls until the operation is canceled. Press [menu/clear] and move the cursor to the DIRECTLINK MODE menu. The display shows TO ENTER DIRECTLINK MODE 2. You will hear a confirmation tone, and DIRECTLINK MODE COMPLETE appears in the display. Making a DirectLinkTM Call 1. To call another handset with DirectLink communication, press [ / flash] . The display shows TO DIRECTLINK A HANDSET PRESS [1-4]. Press the number of the handset you want to call. If the handset is out of range or not set to DirectLink communication, the display shows UNAVAILABLE. To answer a DirectLink call, press [ / flash] . (If Any Key Answer is on you can also press any key on the twelve-key number pad. ) To end the call, press [ ] . Exiting DirectLinkTM Communication While the handset is using DirectLink communication, the display shows DIRECTLINK MODE; this means the handset cannot make or receive normal phone calls. To exit DirectLink communication and return to normal standby, simply return the handset to the cradle, or press [menu/clear] followed by [select/ ] . [. . . ] The answering system announces the number of messages stored in memory and begins the voice prompts. Turn on the answering system remotely 1. Call your phone and let it ring 10 times until you hear a beep. Press 0 then 5 to stop the announcement. [. . . ]