User manual UNIDEN EXP97

[. . . ] removing the handset from the base so you don't have to waste time pushing buttons or flipping switches. AutoStandbyTM allows you to hang up by simply returning the handset to the base. The EXP92's Voice Scramble protects your privacy by scrambling any call you make or receive. The RF signal between the handset and the base are changed, making it difficult or impossible for someone to receive and understand your phone calls. [. . . ] Place the base on the screws and push down until it's firmly seated. After the unit is mounted, raise the antenna. w Mounting Directly on a Wall If you do not have a standard wall plate, you can mount the phone directly on a wall. Before mounting your cordless telephone, consider the following: Select a location away from electrical cables, pipes, or other items behind the mounting location that could cause a hazard when inserting screws into the wall. Make sure the wall material is capable of supporting the weight of the base and handset; otherwise, damage to the unit could result. Use #10 screws with anchoring devices suitable for the wall material where the base will be placed. Insert the screws, with their appropriate anchor device, 3 5/16 inches apart. Allow 3/16 of an inch between the wall and screw heads for mounting the phone. 7. Plug the other end of the telephone line into the telephone wall jack. 8. Plug the AC Adapter into a standard 120V AC wall outlet that is not controlled by a wall switch. Use only the AC adapter that came with the phone. 6 Setting Up Your Phone Extending the Antenna Before using your phone, be sure to raise its antenna to the vertical position. w Low Battery Indicator When the Battery Pack in the handset is low and needs to be charged, the batt low led flashes every 3 seconds. If this occurs while you are on the phone, you hear an alert tone. Complete your call as quickly as possible, and return the handset to the base for charging. Installing the Battery Pack The memory backup feature allows up to 3 minutes after disconnecting the old battery pack to install a new one without losing any phone numbers stored in memory. NOTE 1. Remove the handset battery cover. w Cleaning the Battery Contacts To maintain a good charge, it is important to clean all battery contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner. Do not use any liquids or solvents. 2. Plug the battery's cable into the handset. NOTE The plastic connectors will fit together only one way. Make sure the battery's connector is properly aligned. Adjusting Ringer/Volume Controls w Ringer Tone and Volume 1. The phone has two ringer tones, each with two volume levels. Press G again until you select the ringer tone and volume you want. 3. Replace the battery cover. w Setting the Receiver Volume 1. While you are on a call, press V. w Charging the handset Place the handset on the base to charge. 2. The phone has two receiver volume levels, one soft and one loud. [. . . ] · Disconnect the AC adapter for a few minutes, then reconnect it. · Place the handset back on the charging cradle for a few seconds. · The Nickel-Cadmium battery pack may be weak. The status LED will blink indicating that the phone has been reset. Handset doesn't ring or receive a page. . Charge the battery on the base unit for 15-20 hours. · The handset may be too far away from the base unit. [. . . ]