User manual UNIDEN FRS1200

[. . . ] To determine whether your radio is causing the interference, turn it off. If the interference goes away, your radio is causing it. Try to eliminate the interference by moving your radio away from the receiver. If you cannot eliminate the interference, the FCC requires that you stop using the radio. [. . . ] Insert 3 AA batteries according to the polarity symbols on the inside of the battery compartment. 4 4. Replace the battery cover by pushing it up until it is secure, then latch the clip in place. Low Battery Alert When the batteries in the unit are low, the unit will emit a chirping sound. Replace the batteries immediately to continue using the radio. 5 Belt Clip Installation Because you will most likely use your radio when you are out and about, the unit comes equipped with a belt clip to securely fasten the unit to your belt, pocket or purse. Insert the belt clip screw into the slot on the belt clip. 2. Align the screw with the hole on the back of the radio and turn it clockwise, using a Phillips screwdriver to secure the belt clip. The belt clip can be attached so that it rests vertically or horizontally. Turn the screw counterclockwise to loosen the belt clip and change its position. 7 Using Your Radio In order to get the most out of your new radio, read this reference guide completely before attempting to operate the unit. Turning the Radio On 1. Turn the on/off volume control clockwise to turn the unit on. The unit sounds and the tx LED lights for 0. 5 second. The tx LED will flash every five seconds during standby to remind you the unit is on. 8 2. Turn the control counterclockwise to turn the unit off. Adjusting the Volume 1. Press the MONI button to hear background noise. 2. Turn the on/off volume control clockwise to increase the volume, counterclockwise to decrease the volume. 9 3. Turn the on/off volume control counterclockwise to decrease the volume. 10 Choosing a Channel Your radio has 2 channels you can use to talk to others. In order to speak to someone, each of you must be set to the same channel. To choose a channel for the FRS1200 series: 1. Locate the channel selector switch at the top of the unit. 2. Move the switch to the left for channel 1 or to the right for channel 2. 11 Talking on Your Radio To talk to others using the radio: 1. Press and hold the PTT button and speak into the microphone. When you finish speaking, release the PTT button. Your party cannot send messages through while the PTT button is pressed. 12 Tone Alert for Incoming Calls Your FRS1200 series radio is equipped with a call feature which informs you of an incoming call. A call tone will sound when someone in your party is trying to reach you. To use this feature to contact someone in your party, press the call button. The tx LED lights. This feature is only enabled when both radios are on the same channel. 13 Troubleshooting If your phone is not performing to your expectations, please try these simple steps. Problem No power Message not transmitted Message not received Solution Hearing other conversations or noise 14 · Reposition or replace batteries. [. . . ] THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. This warranty is void outside the United States of America. [. . . ]