User manual UNIDEN GMR1088-2CK REFERENCE GUIDE

[. . . ] GMR1088-2CK · 15 GMRS / 7 FRS Channels · 99 Sub Codes (CTCSS Tone and DCS Code) · Up to 10 Mile Range* · Internal VOX Circuitry · Silent Call · 5 Selectable Call Tone Alerts · Backlit LCD Display · Optional Headset Accessories · Headset Jack · Roger Beep · Power Boost Button for Maximum Range · Battery Charger · Battery Level Meter · Channel Monitor · Channel Scan · Keypad Lock · NOAA Emergency / Weather Channels · Emergency Weather Alert Congratulations on your purchase of the Uniden GMR1088-2CK (General Mobile Radio Service) radio. This product is a lightweight, palm-sized radio. Use it at sporting events to stay in contact with family and friends, hiking, skiing, outdoors, or in a neighborhood watch for vital communication. This compact, state-of-the-art device is equipped with many features. 4) Align the battery cover tabs with the GMR1088 tab holes then replace the cover clip. Normal SUB CODE VOX Level Call Tone Silent Mode Key Lock Normal OFF, 1-99 OFF, 1-3 1-5 ON-OFF ON-OFF BATTERY LEVEL AND LOW BATTERY ALERT This unit has a battery level meter on the display to indicate the status of the batteries. [. . . ] The LCD display will illuminate for 10 seconds before turning OFF. Monitor Mode Feature Your GMR1088-2CK radio allows you to listen for weak signals on the current channel at the press of a key. To turn ON the Monitor Mode: · Press mon for brief listening, the icon will blink. · Press and hold mon for 2 seconds for continuous listening. The receiver circuit will stay open, and letting in both the noise and weak signals. To turn OFF Monitor Mode: Press mon to return to "Normal" mode, and the icon stop blinking. Roger Beep Roger Beep is a BEEP that is sent to notify the end of transmission (PTT, Power boost, and VOX transmission). Roger Beep can be heard through the speaker when key beep is on. Roger Beep is transmitted even if key beep is turned off. However, Roger Beep will not be heard from the speaker. To turn ON Roger Beep: Press and hold the L key while turning ON the radio. To turn OFF Roger Beep: Press and hold the L key while turning ON the radio. USING THE CHARGING CRADLE If you use the rechargeable NiMH battery pack, two GMR1088-2CK radios can be charged by using the charging cradles. Make sure to turn the radio OFF before placing the radio in the charging cradle. Otherwise the battery level meter icon won't indicate properly. 1) Connect the AC adapter (# AD-0001) to DC IN 9V jack and to a standard 120V AC wall outlet. 2) Set the charging cradle on the desk or tabletop, and place the radio in the charging cradle with the keypad facing forward. Charge the battery pack for 16 hours and remove the radio from the charging cradle after charge. Note: The charge indicator LED will remain on as long as the radios are left in the charger. *Range may vary depending on environmental and/or topographical conditions. GMR1088 RADIO GMRS LICENSE The GMR1088-2CK operates on General Mobile Radio Service (GMRS) frequencies when using Channels 1-7 and 15-22. You must have a GMRS license issued by the Federal Communications Commission to legally use these channels. For licensing information and application forms, visit the FCC online at: www. fcc. gov/wtb/uls or call the FCC hotline at 1-800-418-3676. If you have any questions, you can contact the FCC direct at 1-888-225-5322. No license is required for operation on channels 8-14 or operation on any channel in Canada. call wx/ alert sel/ ch/ scan mon vol/ch USING THE RADIO In order to get the most out of your new radio, read this reference guide completely before attempting to operate the unit. [. . . ] Disconnect the battery from the Product and separately secure the battery in its own separate packaging within the shipping carton. The Product should include all parts and accessories originally packaged with the Product. Include evidence of original purchase and a note describing the defect that has caused you to return it. The Product should be shipped freight prepaid, by traceable means, to warrantor: Battery Life · To change the channel continuously, press and hold the L or M key for more than 1 second. Frequency Chart · When in the Weather Radio Broadcast mode, you can only set the Key Lock from the Menu mode. [. . . ]