User manual UNIDEN SC180B OPERATING GUIDE

[. . . ] SC180 100-Channel Programmable Twin Turbo Hand-Held Sports Scanner OPERATING GUIDE Precautions Before you use this scanner, please read and observe the following: n WARNING!Uniden DOES NOT represent this unit to be waterproof. To reduce the risk of fire or electrical shock, DO NOT expose this unit to rain or moisture. Be sure to use only the supplied earphone, or a stereo headset of the proper impedance (32W ). [. . . ] If you want to store the frequency in the selected channel (18) as well, press again. The frequency will blink twice to confirm the programming. Or, you can press and enter another frequency for the currently selected channel. Note: Any frequency already stored in any channel will automatically be replaced by the new one. 8. If you try to enter a frequency that is outside one of the 12 Bands, you will hear a "beep", and the word "Error" appears on the display. Press and re-enter the correct frequency. 9. To program another channel, repeat the above procedures. Deleting a Stored Frequency To delete a frequency from a channel: 1. Display the channel and frequency that is to be deleted. The current channel is erased, and the display shows 000. 0000. Note: That channel will be skipped during scanning. B. Programming SEARCH The Search feature enables you to rapidly search for active frequencies within the specified band limits. When an interesting frequency is found, you can store it into a channel using the procedure below. For more information about SEARCH Mode, see the section titled "Searching". 1. Press and hold SEARCH Mode. /BAND to enter the BAND 15 2. Press and hold the /BAND key to display the preprogrammed Search Bands. Use the and keys or VFO control until you see the Band you want. 3. Wait for at least 2 seconds or press /BAND for Search to begin. If you wish to change the search direction, press and hold or to search in an up or down direction. The next available empty channel to store the frequency will be blinking on the display. 4. When Search stops on a desired frequency, press 5. To store the displayed frequency into that channel, press . The frequency will blink twice to confirm the programming. 6. To store the displayed frequency into another channel: a. [. . . ] BP-180 AT-218 EP-009 AD-70U UA-502 UA-502A BCK-150 FB-150 OMSC180 27 Troubleshooting If your SportCat is not performing properly, try the steps listed below. PROBLEM Scanner won't work. SOLUTION Check the power connections. Make sure the power switch is turned on. Improper reception. Check the antenna connection. Reposition the scanner. Scan won't stop. Adjust the Squelch Control. It is possible that none of the programmed frequencies are active at the time. [. . . ]