User manual UNITED OFFICE ULG 350 A1 LAMINATOR

[. . . ] Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. This laminator is intended exclusively for use in private households and for the hot and cold lamination of documents printed on paper or cardboard. additionally , the documents can be trimmed. It is NOT intended for use with any other materials. [. . . ] The laminator has reached its operating temperature as soon as the green LED indicator light "Ready" u glows. attainment of the operating temperature is indicated by the lighting up of the green LED indicator lamp "Ready" u. For a more uniform laminating result we recommend, especially for thinner foils (below 125 Micron) and after adjustment to a different foil thickness, to first wait an additional 2-3 minutes before beginning with lamination. The red ON / OFF indicator lamp y and the green indicator lamp "Ready" u now glow. Lay the document to be laminated into a laminating pouch of the appropriate size. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch, as shown in Fig. Make certain that you use only one pouch for laminating. For information about the lamination process, please read section 10. If you have previously performed hot lamination: After hot laminating, allow the laminator to cool down completely before beginning with cold lamination. Remember, the rollers inside the laminator will still be hot. If not already done, fold the trimming attachment d down. Pull the document support s out, so that the document can be pulled in straight into the slot for manual pouch input t. Insert the laminator plug into a mains power socket. Lay the laminating pouch onto the pouch guide q. Lay the right or left edge of the laminating pouch against the pouch format lock r (closed side leading). Slide the pouch format lock r together until the selected format size is reached. This prevents the laminating pouch from being pulled in at an angle. Should the laminating pouch be pulled in at an angle, use the "Anti-Blocking Funktion" as described in chapter 11. Now slide the laminating pouch slowly into the When you have slid the laminating pouch several Centimetres into the slot t, it will start to be pulled in automatically. Release the laminating pouch as soon as you notice it being pulled in automatically. [. . . ] Cleaning the interior of the appliance: With every lamination, contaminants are deposited on the rollers inside the laminator. over time , this reduces the performance of the laminator. You should therefore clean the rollers inside the laminator after use. Do not dispose of the appliance with your normal domestic waste. [. . . ]