User manual UNITED OFFICE UTB 250 A1 THERMAL BINDER

[. . . ] The heating plate at the bottom of the binding shaft 1 1 becomes very hot. Place the appliance where the power wall socket is easily accessible, so that in the event of an emergency the plug can be quickly withdrawn. [. . . ] As soon as the green control lamp 6 glows the appliance has reached its operating temperature. Select a suitable thermal binder cover for your document: Number of sheets 80g/m2 max. As soon as an acoustic signal sounds and the control lamp 6 glows constantly you can remove the thermally bound brochure from the binding shaft 1. After use, place the ON/OFF switch 4 at O and remove the plug from the mains power socket. If you want to bind documents with more than 100 pages, repeat the binding process several times. For 300 pages you must carry out the binding process at least 2-3 times. Always remove the plug from the mains power socket before you clean the appliance!Never submerse the appliance into water or other liquids!Always select the next largest binder if you want to bind more pages than are suitable for the binder. Tap the sides of the sheaf of papers a few times to ensure that ALL of the sheets are lying exactly above each other. Lay the sheets into a suitable thermal binder cover and then tap them down a couple of times, against and using the cover spine. Slide the complete thermal binder brochure into the binder shaft 1 until the spine of the brochure makes firm contact with the hotplate on the floor of the thermal shaft 1. Allow the appliance to cool down completely. Clean the surface of the housing with a slightly damp wash cloth. [. . . ] The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. Your statutory rights are not restricted in any way by this warranty. [. . . ]