User manual UNIVERSAL REMOTE CONTROL ATLAS 5-DEVICE

[. . . ] ATLAS DVR/PVR 5-DEVICE Universal Remote Control User's Guide Atlas DVD/PVR Manual 2/14/03 5:00 PM Page 2 TABLE OF CONTENTS Introduction. 13 Setup Codes For Cable Boxes (Converters) . 15 Setup Codes For Satellite Receivers . 26 To De-Activate Channel Control Lock . [. . . ] Then press and hold SETUP until the TV key blinks twice, then release SETUP. The TV key will blink twice. 2. 3. To view the code for the first digit, press 1 once. Wait 3 seconds and count the number of times the TV key blinks (e. g. , 3 blinks = 3) and write down the number in the leftmost TV Code box on page 11. NOTE: If a code digit is "0", the selected mode key will not blink. 4. Repeat step 3 three more times for the remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Finish writing down the code in the TV Code boxes on page 11. To check for other device codes, repeat steps 1 through 4, but substitute the appropriate key (e. g. , AUX, DVD, AUD, or CBL) for the device you are checking. Write down the codes in the appropriate boxes on page 11. 5. 25 Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 26 PROGRAMMING CHANNEL CONTROL LOCK By default, the remote control's channel-control capabilities are locked to the cable converter. The affected keys* are 0 ~ 9, CH+, CH-, ENTER, and LAST. This will guarantee that you do not inadvertently change a channel on your TV or VCR. However, you can de-activate this feature to allow full access to these keys in the TV and VCR modes. *NOTE: This feature does not affect the AUD mode. To De-Activate Channel Control Lock: 1. On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice, then release SETUP. The CBL key will blink twice. 2. 3. Now, the remote control will provide TV and VCR channel-control capabilities while in the TV or VCR mode. To Re-Activate Channel Control Lock: 1. On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice, then release SETUP. The CBL key will blink twice. 2. 3. Now, regardless of what mode you select (except AUD), only the channel control capability of your cable converter will be accessible. 26 Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 27 PROGRAMMING ID LOCK The Atlas DVR/PVR 5-Device Universal Remote Control is locked at the factory to operate a Scientific Atlanta cable converter. However, if you have another brand or model of cable converter or satellite service that you would like to control, then you'll need to perform the following steps to unlock the ID Lock, enter in a new manufacturer's code, and lock the ID Lock again. On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice, then release SETUP. The CBL key will blink four times, indicating ID Lock is unlocked. 3. 4. Perform the instructions in Programming Device Control on page 10 to program device control for the desired cable converter or satellite receiver. Upon completion, perform the remaining steps (5 and 6 on this page) to again lock the ID Lock. On the remote control, press CBL once; it will blink once. [. . . ] PROBLEM: TV/VCR Combo does not respond properly. SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full operation (see page 12). SOLUTION: Follow instructions in Changing Volume Lock (see page 31). [. . . ]