User manual UNIVERSAL REMOTE CONTROL CHARTER

[. . . ] Generic Pioneer Charter OCAP. fm Page 1 Friday, July 20, 2007 1:28 PM C4000 and S4000 Universal Remote Controls Users Guide PREPROGRAMMED FOR YOUR SET-TOP BOX Generic Pioneer Charter OCAP. fm Page 2 Friday, July 20, 2007 1:28 PM TABLE OF CONTENTS Introduction . 4 Key Charts: C4000 and S4000 Remote Controls . 15 Unlocking Volume Control for a Single Device (Individual Volume Unlock) . 16 Unlocking All Volume Control (Global Volume Unlock) . [. . . ] Repeat step 3 three more times for the remaining digits. Use 2 for the second digit, 3 for the third digit, 4 for the fourth digit, and 5 for the fifth digit. Finish writing down the code in the TV Code boxes on page 11. To check for other device codes, repeat steps 1 through 4, but substitute the appropriate key (e. g. , AUX, DVD, CBL, or STB) for the device you are checking. Write down the codes in the appropriate boxes on page 11. 5. www. urcsupport. com 14 Generic Pioneer Charter OCAP. fm Page 15 Friday, July 20, 2007 1:28 PM PROGRAMMING CHANNEL CONTROL LOCK By default, the remote control's channel-control capabilities are locked to the cable converter. The affected keys* are 1 through 0, CH+, CH-, and LAST. This guarantees that you do not inadvertently change a channel on your TV or VCR. However, you can deactivate this feature to allow full access to these keys in the TV and VCR modes. On the remote control, press CBL (or STB) once; it blinks once. Press and hold SET UP until the CBL (or STB) key blinks twice. The CBL (or STB) key blinks twice. 3. Press CH- once. The CBL (or STB) key blinks four times. Now the remote control provides TV and VCR channelcontrol capabilities while in the TV or VCR mode. On the remote control, press CBL (or STB) once; it blinks once. Press and hold SET UP until the CBL (or STB) key blinks twice. Enter 9 7 3. The CBL (or STB) key blinks twice. 3. Press CH+ once. The CBL (or STB) key blinks twice. Now, regardless of what mode you select, the channel keys only change channels on your cable converter. CHANGING VOLUME LOCK Volume Lock allows you to control the volume through the device identified as having your primary speaker(s), regardless of which mode you are using. On the C4000 and S4000 Remote Controls, Global Volume Lock is set to TV, so you can control TV volume while in the AUX, www. urcsupport. com 15 Generic Pioneer Charter OCAP. fm Page 16 Friday, July 20, 2007 1:28 PM DVD, TV or CBL mode. You can perform Individual Volume Unlock on a selected device to set its volume control for independent operation. Unlocking Volume Control for a Single Device (Individual Volume Unlock) 1. Assuming Global Volume Lock is active, select a mode on the remote control that you want to unlock (e. g. , CBL) and press it once. Next, press and hold SET UP until the device key blinks twice. The last-selected device key blinks twice. 3. Press VOL- once. [. . . ] PROBLEM: TV/VCR Combo does not respond properly. SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full operation (see page 11). SOLUTION: Follow instructions under "Changing Volume Lock" on page 15. [. . . ]