User manual UNIVERSAL REMOTE CONTROL MRF-250

[. . . ] The PowerBlasterTM picks up RF remote control radio frequency signals from any direction, regardless of distance, so the remote doesn't need to be pointed directly at any Component. Now you can close your entertainment center doors, hide your Components, and still control them with ease. One of the best things about this is - nothing has to be done to the remotes themselves for this feature to work. [. . . ] One of the best things about this is - nothing has to be done to the remotes themselves for this feature to work. Every time you press a button on one of the MasterControlTM RF series remotes, it sends both a standard IR (Infrared Command) AND an RF (Radio Frequency) signal. When you install the PowerBlasterTM kit, it will automatically receive radio signals from RF series remotes and translate them into the infrared commands that control your Components. Quick Setup DVD Guide makes installation easy!The Quick Setup DVD Guide will assist you in setting up PowerBlasterTM to work with your RF series remotes by guiding you through an easy step-by-step process. This Owner's Manual is designed as a companion reference source to the DVD Setup Guide, should you need to refer back to a particular section, or review certain instruction detail not covered in the DVD. However, if you are unable to watch the DVD Guide for some reason, everything you need to know about setting up PowerBlasterTM is contained in this Manual. NOTE: PowerBlasterTM is only compatible with Universal Remote Control's MasterControlTM RF series remote controls (RF10, RF20, RF30). RF series remote control radio signals will not control Components directly. You must have a PowerBlasterTM to receive the RF remote radio signals. PowerBlasterTM can interfere with testing and programming. STEP 1: Included 9V power supply plugs into the MRF-100 power connector. Turn ON all of your components. Audio /Video components sometimes create RF interference. Therefore, perform all testing with all of your components powered ON (as they will be when you operate the system). If there is any flickering, move PowerBlasterTM farther away from the A/V components. STEP 4: Orient the Antenna for Optimum Range. If you need to extend the range of the remote, try adjusting the angle of PowerBlaster'sTM receiving antenna via it's pivoting ball mount. PROGRAMMING SETP 2: PARTS GUIDE Six flasher jacks on the rear of PowerBlasterTM connect flashers for control of A/V components out-of-sight of the front blaster. Connect the Power Supply. Connect the 9V power supply to an active UNSWITCHED AC outlet. PowerBlasterTM must always be powered up. The red Power LED should light up. STEP 5: Mount PowerBlasterTM. [. . . ] PowerBlasterTM must always be powered up. The red Power LED should light up. STEP 5: Mount PowerBlasterTM. PowerBlasterTM may be concealed and mounted to the rear wall or back of the system cabinet. [. . . ]