User manual UNIVERSAL REMOTE CONTROL ONE FOR ALL URC4041

[. . . ] IMPVE4P manual 1. 0 4/11/03 4:34 PM Page 1 DVD EXPERT Universal Remote Control URC-4041 User's Guide IMPVE4P manual 1. 0 4/11/03 4:34 PM Page 2 TABLE OF CONTENTS Introduction . 12 Programming The Power Key For The Master Power Macro . 13 Restoring Keymoved Keys To Default Settings. 14 Restoring All Keymoved Keys In A Single Mode . [. . . ] After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on or off your devices. NOTE: When POWER is pressed for less than 2 seconds, a power command will only be sent to the currently-selected device. This allows you to still individually power devices on or off. 4. 5. Operating The Master Power Macro 1. 2. You will see the devices turn on or off according to your programmed sequence. NOTE: The currently-selected device will always turn on or off first, followed by the remaining programmed sequence. After the master power sequence has been completed, the remote control will be set to control the first powered-on device. NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). This action is normal. 12 IMPVE4P manual 1. 0 4/11/03 4:34 PM Page 13 Clearing The Master Power Macro 1. Press and hold SET until the LED (red light) blinks twice, then release SET. Then press POWER once. 3. Press and hold SET until the LED blinks twice, then release SET. The Master Power Macro is now cleared. USING KEYMOVER The One For All DVD Expert Universal Remote Control includes a Keymover feature that allows you to map (or copy) keys from one mode (i. e. , source mode) to another mode (i. e. , destination mode). NOTE: The following keys should not be used as a source or destination: DVD/VCR, AUX, CBL/SAT, TV, SET, FAV, and REC. Programming Keymover For example, if your DVD player does not have volume control, you can map those keys (i. e. , VOLL, VOLM, and MUTE) from TV mode to DVD/VCR mode as follows: 1. Press and hold SET until the LED (red light) blinks twice, then release SET. 8. For the source mode, press TV once. For the destination mode, press DVD/VCR once. For the destination key, press VOLL once. The LED will blink twice, indicating the keymoved sequence is correct. Repeat steps 1 through 7 twice more to map remaining volume control keys, substituting VOLM and MUTE as source and destination keys in steps 4 and 6. 13 continued on next page. . . IMPVE4P manual 1. 0 4/11/03 4:34 PM Page 14 USING KEYMOVER Programming Keymover (continued) Upon completion of the above procedure, you can now use your One For All DVD Expert Universal Remote Control to control the TV's volume and mute in the DVD mode, as well as in the TV mode. Restoring Keymoved Keys to Default Settings Restoring A Single Keymoved Key 1. Press a device key that has a keymoved key. Press and hold SET until the LED (red light) blinks twice, then release SET. The LED will blink twice. 4. Press the destination key twice (where the keymoved key is stored). Press and hold SET until the LED (red light) blinks twice, then release SET. The LED will blink twice. Restoring All Keymoved Keys In A Single Mode 1. 2. 3. Press the destination mode twice (where keymoved keys are stored). The LED will blink twice. RE-ASSIGNING DEVICE KEYS The One For All DVD Expert Universal Remote Control can be set to control a second TV, PVR, VCR, DVD player, or other device. [. . . ] This warranty does not cover damage or failures caused by products or services not supplied by OFA, or which result from accident, misuses, abuse, neglect, mishandling, misapplication, faulty installation, set-up adjustment, improper maintenance, alteration, maladjustment of consumer controls, modifications, commercial use, or that is attributable to acts of God. There are no express warranties except as listed above. OFA SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF WARRANTY, ALL EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE WARRANTY PERIOD SET FORTH ABOVE. Some states do not allow the exclusion or limitation of incidental or consequential damagers, or limitations on how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. [. . . ]