User manual UNIVERSAL REMOTE CONTROL UR3-SR2

[. . . ] If any of the functions do not operate as they should, repeat the instructions from Step 2 using the next three-digit code number from the same brand list. 4 Programming the Remote Control. *Note : In this section, when you are instructed to press a [DEVICE] button, that means you should press either the CBL, TV, or VCR button, depending on which device you are programming the remote to operate. B. Auto Search Method If none of the three digit code numbers assigned to your brand of equipment works, or the code table does not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your equipment by following steps: A. Manual Programming The remote control can be programmed by entering a threedigit code number that corresponds to particular brands and models of equipment. [. . . ] The device LED will blink twice to confirm that the code has been stored. STEP4 Press the same [DEVICE] button to store the code. The Device LED will blink twice to confirm that the code has been stored. E. Programming for Advanced Functions. In the CABLE device mode, the A, B, C and blank macro buttons can be programmed to act as macro buttons to send out up to 10 commands with one button press. In this section, when you're instructed to press a [MACRO] button, you need to press either the A, B, C or blank macro button (depending on which button you are attempting to program). *Note : The A, B, and C buttons are not programmable if you have a Digital Cable Box made by Pace, Pioneer, or Scientific-Atlanta. C. To find the Thr ee-Digit Code that W as Pr ogrammed using the Auto Sear ch Method STEP1 Press the appropriate [DEVICE] button and the [SELECT] button simultaneously for three seconds. The device LED will turn on for 20 seconds. The next step must be performed while the LED is on. STEP2 Press the [INFO] button. The device LED will blink a number of times indicating the number of each digit for the code. Each digit is separated by a one second interval of the LED being off. Example : One blink, then three blinks, then eight blinks indicates the code number 138. *Note : Ten blinks indicates the number 0. STEP1 Press the [CBL] button to select the CABLE mode. STEP2 Press a [MACRO] button and the [SELECT] button simultaneously for 3 seconds. The CBL device LED will turn on for 20 seconds. The next step must be performed while the LED is on. STEP3 Press up to 10 buttons you wish to store. The CBL device LED will blink once for each command entered. 4 5 STEP4 Press the [CH+] button to store the functions that are selected. The CBL device LED will blink twice to confirm the storage of functions. Example : If you wish to have the volume and mute keys operate your Cable Box, press the [CBL] button in Step3. To erase the Macro programming and return to the original function: STEP1 Press the [CBL] button to select the CABLE mode. STEP2 Press a [MACRO] button and the [SELECT] button simultaneously for 3 seconds. The CBL device LED will turn on for 20 seconds. The next step must be performed while the LED is on. [. . . ] The device LED will turn on for 20 seconds. The next step must be performed while the LED is on. H. Low Battery Warning When the battery is low (2. 3V-2. 0V) and needs to be replaced with fresh batteries, device LED will blink 2 times in sequence whenever a [DEVICE] button is pressed to turn on equipment. STEP2 Press the [VOL +] button. [. . . ]