User manual UNIVERSAL REMOTE CONTROL UR5U-8700L SPECS SHEET

[. . . ] The Component LED light will blink twice to confirm that the code was successfully stored. Now, program the rest of your Components by repeating STEPS 1-5. *Note : If the Pre-Programmed Method did not work, or if the Code Tables do not list your Component brand, use the AutoSearch Method as explained in Section B. STEP4 Test functions. (Same as for 3-Digit Code Programming Method - Section A). [. . . ] STEP5 Once you have found the correct 3digit code, save it by pressing the [AUX] button one more time. The Component LED light will blink twice to confirm the code was stored. Now when you press the AUX button, all the buttons will work with that 5th Component. G. Programming Volume Control channel you want programmed first (for example, 007) using the Number Pad, then press the [STOP] button. Then enter the code for the next channel (for example, 050), then press the [STOP] button. Repeat this process for the third channel. The [CBL] button will blink once for each channel entered. E. Programming the System On/Off Button This allows you to program the System On/Off button so it can send up to five power On/Off commands with one button press. STEP2 Press the [SYSTEM ON/OFF] button and the [OK/SEL] button simultaneously for 3 seconds. The [CBL] button will turn on for 30 seconds. STEP3 Press the first [COMPONENT] button you want to store in the [SYSTEM ON/OFF] button and then the [POWER] button. Repeat this for other Components until you have stored all the desired power commands into the [SYSTEM ON/OFF] button. STEP4 Press the [CH ] button to save the power commands you stored. The [CBL] button will blink twice to confirm the commands have been saved. Volume and Mute control are factory- STEP4 Press the [CH ] button to store the channels that were selected. The [CBL] programmed to automatically transfer to the button will blink twice to confirm the respective Component mode you select, as storage of commands. follows: To access the programmed channels, press the [MACRO] button once. Press once again and it will However, you can program the volume controls bring up the second channel. Press again and (Volume Up, Volume Down and Mute) from one it will bring up the third channel. Component to operate in another Component. CBL : CBL DVD: TV T V : TV AUX: AUX VCR: TV If you wish to store the TV volume control in I. Low Battery Warning CBL mode, use the following steps. When the batteries are low and need to be STEP1 Press the [CBL] button and the replaced with fresh batteries, the Component [OK/SEL] button simultaneously for 3 LED lights will blink 2 times in sequence seconds. [. . . ] STEP1 Turn on the 5th Component you want to program (TV, VCR, DVD or Audio). STEP2 Press the [AUX] button and the [OK/SEL] button simultaneously for 3 seconds. The [AUX] Component LED will turn on for 30 seconds. STEP3 Press the [COMPONENT] button you want to setup. Point the remote control toward the Component and enter the 3digit code number assigned to your brand. The Component LED will blink twice to confirm the programming. F. [. . . ]