User manual UNIVERSAL REMOTE CONTROL UR5U-BH8000

[. . . ] *Tip : The device LED will turn on for 20 seconds. The next step must be entered while the LED is on. The device LED will blink number of times indicating the number of each digit of the code number. Each digit is separated by a 1 second interval of the LED being turned off. [. . . ] Low Battery Warning. When the batteries are low and need to be replaced with fresh batteries, the remote control LED will blink 2 times in sequence whenever a [POWER] button is pressed to turn on equipment. B. Auto Search Method. If the three-digit code numbers assigned to your brand do not turn off your equipment or the code tables do not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your equipment by the following steps: STEP1 Turn on the equipment you wish to operate. STEP2 Press the [DEVICE] button (TV, VCR, DVD or AUX) to be programmed and the [SELECT] button simultaneously for 3 seconds. Programming a second TV to AUX Mode. STEP1 Press the [AUX] button to be programmed and the [SELECT] button simultaneously for 3 seconds. The [AUX] device LED will turn on. *Tip : The device LED will turn on for 20 seconds. The next step must be entered while the LED is on. STEP2 Press the [TV] device button to pick up the TV code table. STEP3 Point the remote control toward the equipment and enter the three-digit code number assigned to your TV brand from the code tables. STEP4 Store the three-digit code number by pressing the [AUX] button once again. The device LED will blink twice to confirm that the code has been stored. If you wish to store the TV channel control in TV mode, use the following steps. STEP1 Press the [TV] button and the [SELECT] button simultaneously for 3 seconds. *Tip : The device LED will light on for 20 seconds. The next step must be entered while the LED is on. The device LED will blink twice to confirm the programming. To return to original state: If you wish to restore the CABLE channel control in TV mode, repeat the above steps by pressing [CBL] in STEP3 . I. Memory Lock System. This remote control is designed to retain programmed memory for 10 years even after batteries are removed from the remote control. J. Write your device Set-up codes. TV VCR DVD AUX Set-up Code Number: Set-up Code Number: Set-up Code Number: Set-up Code Number: 4 Operations Default State: Device Default: CABLE Volume Default: You have the option of controlling your TV volume and mute through the Cable box, VCR or DVD. Refer to section G for programming the volume and mute through your Cable box, VCR or DVD. Channel Default: You have the option of controlling your CABLE channel and number keys through the TV or VCR. Refer to section F for programming the channel and number keys through your TV or VCR. System On/Off button: This button is designed to send out power commands for two, three, four or all five devices with one button press. [. . . ] Release the [CH+] or [CH-] button as soon as the equipment turns off. *Tip : You can verify that you selected the correct code by pressing the [POWER] button. The equipment should either turn on or turn off. STEP4 Press the same [DEVICE] button to store the code. [. . . ]