User manual UPM WS220

[. . . ] It is now ready for set up. Temperature and humidity (for WS220H & WT260H only) are displayed on the Lower Display Area which consists of the Right and Left Display Boxes. When Humidity data is available, the display will toggle between temperature and humidity displays. Alarm To set the alarm, press SET in Alarm mode. Hour will be flashing as in Figure 2. ALARM ON ALARM ON ALARM COUNTDOWN TIMER MODE MINUTE SECOND Functions of Weather Station Clock Setting To set the clock, press SET key in Clock mode. Hour will be flashing as in Figure 1. FIGURE 2 LOCAL HOUR PM DEGREE FAHRENHEIT C C C C FC DEGREE CELSIUS LOCAL TEMPERATURE MAXIMUM TEMPERATURE MINIMUM TEMPERATURE FC REMOTE TEMPERATURE RF THERMO 1 LOCAL RF THERMO 1 FIGURE 3 CHANNEL NUMBER RF THERMO INDICATOR Features of Weather Station WS220 Local temperature display with maximum and minimum temperature memory in ºC or ºF. [. . . ] (Figure 4) C C To move from one mode to the other, press the MODE key. The Weather Station will return to the Clock Display automatically when no key is pressed for 1 minute. LOCAL RF THERMO 1 FIGURE 4 2 3 4 6 7 8 Use the same method as in clock setting to set the hour, minute and second desired. The range of countdown time is from 1 second up to 23 hours 59 minutes 59 seconds. To start the countdown, press ST/SP in Countdown Timer mode. A beep will sound and count down starts. Press ST/SP during countdown will pause the process. Countdown will continue even if you change the display to another mode. When Countdown is finished, the display will jump to the Countdown Time, and will flash sounding the alarm . Press any key except SNOOZE to stop the alarm. (If SNOOZE is pressed, the alarm will stop and sound again after 5 minutes. Remote Temperature Display By using RF technology and simple Learn function, the Weather Station can receive remote signals from up to 4 Remote Transmitters (WT260) which can be placed indoor / outdoor wherever you desire within the transmission range. To enable the Weather Station to receive signals from each Remote Transmitter, identical House Code and different Channel Numbers must be assigned to each Remote Transmitter in use. Please follow the procedures below to set the Remote Transmitter(s) to work with the Weather Station. The Setting mode will end after no key is pressed for 12 seconds. During the setting process, you may press the RESET button anytime to restart the setting process. After initial setting, please do not press the 2 buttons again. Otherwise the Learn procedure of the receiver will need to be repeated. After setting, the current temperature and humidity (WT260H only) will be displayed. The data will then be transmitted to the receiver every minute (Figure 9). 18. 7 C FIGURE 9 Setting the Remote Transmitter(s) There are 2 buttons at the back of transmitter. Press the RESET button (right side) to start the setting procedure. House Code will be flashing with "01" as in Figure 7. If desired, press SET button (left side) to change the House Code. [. . . ] In this mode, the display will scroll through data from all the valid channels, each of which will be shown for 20 seconds. FIGURE 13 In each case, batteries should be replaced. After installation of new batteries, the set up procedure will need to be performed again. Technical Specification Weather Station WS220 2 x 1. 5V AA size batteries (or equivalent) From 1 Sec. Avoid locations too close to metallic objects. Check if the data from Remote Transmitter can be received by the Weather Station from each of the selected locations. [. . . ]