User manual US ELECTRONICS NOVARI MOTOROLA

[. . . ] NOTE: if you are setting up the remote for a: follow these instructions as if it were a: TV/VCR Combo . . DVD player (please read section 16 before continuing) Personal Video Recorder . . VCR Channel Lock prevents the channel up and down functions from operating any device other than the set-top box -- no matter which device (TV, CABLE, VCR, DVD, AUDIO) is currently selected. The Novari comes with Channel Lock activated. [. . . ] Press and hold the appropriate device key for approximately three seconds until the five device keys flash twice. The selected device key will continue to flash. The device key will stop flashing and remain on. Approximately once every second, the remote sends the power-off command using a different device code. When the device turns off, that means that the remote has reached a code that can control the device. Immediately release the UP ARROW key when the device turns off. If you accidentally press the UP ARROW key after the device has turned off, press the DOWN ARROW key to return to the previous device code. The Up Arrow Key 4 Write the codes below 3 Set-top Box code ___ ___ ___ VCR Code ___ ___ ___ TV code ___ ___ ___ Audio Code ___ ___ ___ DVD Code ___ ___ ___ 5 PROGRAMMING VOLUME CONTROL By default, the TV, CBL, or AUD keys will send their own volume and mute signals to their device. If you would like to set up the Novari so that volume is always controlled by a particular device (set-top box, TV, or audio amplifier), follow these steps: 4 1 2 Press and hold the CBL key for approximately three seconds until the five device keys flash twice. Press VOLUME UP then VOLUME DOWN then the Device Key (TV, CBL, or AUD) of the device that you want to control volume and mute functions. After you release the Device Key, the CBL key will blink three times to confirm the procedure. Test whether other functions operate using the remote control. If a primary function does not work, continue to press the UP ARROW key to find another code that turns off the device. When you are satisfied that all primary functions are working, press OK to lock in the code. 9 RECALLING A DEVICE CODE NOTE: volume will always be controlled by your audio device when the remote control is in AUD mode -- regardless of how you set up volume control in this section. Perform the following steps to read the code currently set for a device. This is useful for retrieving a device code that was set using the SmartScanTM procedure. 6 MASTER POWER CONTROL 1 2 Press and hold a device key until the five device keys flash twice. The selected device key will continue to flash. The device key flashes each of the three digits in the code. For example, three flashes represent the number 3, and a rapid flicker represents 0, so a code of 103 will be shown as: FLASH <pause> FLICKER <pause> FLASH FLASH FLASH Count and record the sequence of flashes to determine the three-digit code. You can program your Novari to turn on and off all of your remote-controlled devices (TV, CABLE, VCR, DVD, AUDIO) when you press POWER. All devices must be in direct line of sight to ensure proper operation. Perform the following steps to enable or disable power control for each device: 1 2 3 Make sure all devices to be controlled are turned on. Press and hold the CBL key for approximately three seconds until all five device keys flash twice. If you own one of these models, note that there are two codes listed below. [. . . ] Consult related owners manuals for specific installation and operation instructions for each device. Problem The channel keys only operate my set-top box. Solution Make sure that Channel Lock isn't engaged. Follow the steps in section 7 to disengage Channel Lock. [. . . ]