User manual US ROBOTICS USR0756-XJ QUICK START

[. . . ] Robotics 56K PC Card Modem with XJACK® Connector Quick Installation Guide for Windows 95, 98, Me, NT 4. 0, 2000, and XP Operating Systems Model 0756 Part Number R24. 0323. 00 U. S. Robotics Corporation 935 National Parkway Schaumburg, Illinois 60173-5157 USA No part of this documentation may be reproduced in any form or by any means or used to make any derivative work (such as a translation, transformation, or adaptation) without written permission from U. S. Robotics Corporation reserves the right to revise this documentation and to make changes in the products and/or content of this document from time to time without obligation to provide notification of such revision or change. Robotics Corporation provides this documentation without warranty of any kind, either implied or expressed, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose. [. . . ] You will see a list of installed modems. Windows NT 4. 0, Me, 98, and 95: Click Windows Start, Settings, and Control Panel. You will see a list of installed modems. You can also add, remove, or view the properties of modems from this window. Robotics modem you have installed should be present in the list of installed modems. If none of the modem descriptions in the list matches your U. S. Robotics modem or if no modems are listed, your modem is not installed properly. Possible solution: If you are using Dial-up Networking, it may not be configured correctly. Check your configuration and make sure that the correct port is selected. Windows XP and 2000: Click Windows Start, Control Panel (or Settings in Windows 2000), and Network and Dial-up Connections. Right-click the connection you are trying to use, and then click Properties. Make sure that the description in the "Connect Using" box (under the General tab) matches the description of the modem you are using. If it does not match, select the proper modem description. Windows Me, 98, and 95: Double-click the My Computer icon on your desktop, and then double-click Dial-up Networking. Right-click the connection you are trying to use and click Properties. Make sure that the description in the modem box matches the description of the modem you are using. If it does not match, select the proper modem description. Windows NT 4. 0: Click Windows Start, Settings, and Control Panel. Your modem should be in the Device window. Possible solution: Your communications software may not function properly if you have more than one version of the software installed, you are using an older version, or you have more than one communications application installed on your system. We highly recommend using the communications software provided with your modem on the Installation CD-ROM. My modem is responding but is reporting a No Dial Tone message. Possible solution: Your phone cord may not be plugged into the modem's connector. Also make sure that the other end of the phone cord is plugged into a working telephone wall jack. [. . . ] Robotics Service Center within the applicable warranty period to obtain warranty service authorization. Robotics or its authorized reseller may be required. Robotics Corporate Service Center must be pre-authorized by U. S. Robotics with a Return Material Authorization (RMA) number or User Service Order (USO) number marked on the outside of the package, and sent prepaid and packaged appropriately for safe shipment, and it is recommended that they be insured or sent by a method that provides for tracking of the package. [. . . ]